Ohm meter question

Discussion in 'Cloud 9 Vaping' started by liquidator, Nov 10, 2013.

Thread Status:
Not open for further replies.
  1. liquidator

    liquidator Senior Member

    Hi,
    I am new to mechanical modding, I have placed an order for a Svoemesto extended kit and Kayfun atomiser plus the ohm meter below.

    my question is, is this meter sufficient, I know it will read ohm,s and after watching a video review, I believe it will give an adnormal reading if there is a short, is this ok or should I purchase a multi meter too?

    (I have read the safety sections concerning protected batteries etc)

    USB powered ohm-meter - Cloud 9 Vaping
     
  2. Scott_Simpson

    Scott_Simpson Ultra Member Verified Member

    Supporting member
    This looks similar to the one I use, except mine is battery powered rather than USB powered. Should be fine ... :)
     
  3. liquidator

    liquidator Senior Member

    Thanks, Scott.
     
  4. State O' Flux

    State O' Flux Vaping Master Verified Member

    The Nivel chip in the Semovar is pretty comprehensive... so although I'd always recommend a DMM for any sub-ohm vaping, for a Kayfun, it probably will not be necessary. I have yet to build below 1.4Ω with any Kayfun or clone and usually run at 1.7-1.8Ω.

    A flat top ohm meter, if for no other reason than it makes a nice build platform, is always good to have around.

    Here's a link to a pdf owners manual, in English... that you may find useful.
     
  5. vapn

    vapn Supplier Associate

    The Ohm meter we have is either battery or USB powered.
     
  6. liquidator

    liquidator Senior Member

    Thanks for the replies and links.
     
Thread Status:
Not open for further replies.

Share This Page