Okay to use eGo ONE minI clearomizer with iStick Mini?
- Thread starter Anonymou136
- Start date
- th_trl_thread_readers 0
- Status
I wish I could answer this for you but I have to say it looks great! I will be watching this thread for responses because I love my istick minis and I am always looking for new tanks!
It's just another tank. I use mine with a 1.2 ohm clr head on an old joyetech evic easy mode.
BTW, a 1.0 ohm coil at 10 watts would be like 3.2 volts...if my math is correct.
BTW, a 1.0 ohm coil at 10 watts would be like 3.2 volts...if my math is correct.
I would believe that if the istick mini couldn't handle the 1. ohm tank set up, it would shut down as most have circuitry protection.
I think that you would not get a very satisfying vaping experience out of that setup
10 watts is a bit low for a 1 ohm coil. You could get the CLR coils, which are easier to rebuild, and build a little higher.
I think I'd stick in the lower part of the voltage range to keep the watts safely below 10. I'm not sure how the vape will be that low.
The iStick Mini tops out at 10W and it's a bit low on power for that particular head, but it'll work just fine at that power level, if a little weak. You're right at the lower resistance threshold for the battery, so don't try the 0.5 ohm coils... they won't fire at all. If you want a bit more oomph, consider the Mini iStick 20W... it looks identical, offers actual wattage regulation, and caps out at 20 watts. Probably more suited to the 1.0 ohm CL coils that tank uses. It still won't handle the 0.5 ohm coils, though.
Thank you guys. I'm into the mouth to lung hits and not looking to blow clouds. I use 12mg nic juice and so far is hitting amazingly for me. I was using the nautilus mini with 1.8ohm could but wasn't enjoying the hits at all. So I tried the ego one mini with 1.0 ohm could and it feels perfect and looks better. This device is so small I love it.
- Status
Similar threads
- Locked
- Locked
