Some of my mechs go beyond what most mech enthusiasts would enjoy.
The revolver is one of them.
It has a ton of parts and the brass deck is press fit into the aluminum body.
I wouldn't recommend it unless you love working on your gear and understand what a disaster of a design this is.
That said, it hits harder than Conor McGregor and draws more attention than a bald Kardashian.
How much do you want for that??
2+2=5 [emoji102]
Just order your own from 3Fvape.
It's a clone.
It was only about $20.
Nice Trio! I love the look of those Bamboo mechs!Old school....lol
View attachment 629179
If the authentic is anything like the clone...its a PITA to get it to work properly all the timeNice Trio! I love the look of those Bamboo mechs!
Thanks for the info, sounds perfect.The Kraken v2.5 24mm arrived
Slapped a Ni200 0.15 vertical SSOCC in (after disassemble & Isopropyl cleaning and O-ring lube), filled with Mech Sauce "Batter Up", loaded onto the VA Primo, set at 24W & 468* F, and Aww Hail Yay-issss Very Nice. She vapes as good as she looks. Will reconfig. with a Ti-built RBA later on.
Nice to have the choice in a Rockin' Quality Chassis
View attachment 629027
@TrollDragon, she does have the typical intake lisp/hiss as a TopTank/SubTank does (I run the AFC about 40-50% open) but no annoying whistle till the AFC closed to @20% open and less. Not an issue for me but would prevent covert vaping with nothing else going on around.
Thanks for the info, sounds perfect.
A real looker for sure! Did the Primo come from Enushi as well?
I'll have to do some serious pondering, sweet vape gear doesn't have a high WAF in my house.