Hi, I've been scouring the internet for days looking for an answer for this, but no luck. I recently purchased the Kangertech Topbox Mini. I'm using the 0.15 ohms Ni200 coil, which apparently you should only use in temperature control mode.
To put it in temp control mode, I'm pressing the fire button three times and choosing the 'Ni' option. However, I can then only adjust the temperature and not the wattage, which appears on the screen as 75watts. From what I've read online - and, indeed, from the instructions which came with the device - this is too high. It's recommended to only vape with this coil between 20-45w.
I've also found that I get no vape at all when using a low temperature, such as 200 degrees C, in temp mode - but when I up the temperature, I get a burnt taste and sometimes the battery flashes (depsite charge) or rapidly depletes. Although I am also having battery issues in power mode. I'm currently vaping this coil using the only mode where I can change the wattage, at 20w, and am finding the device gets very hot and the battery only lasts a few hours (although this could be due to over-vaping!). I'm using a 18650 battery, as recommended in the instructions.
I'm utterly confused as to which setting to use for this coil and why all the advice is to vape in temperature control mode when you cannot change the wattage on this device? If Kanger recommend vaping this coil between 20-45w, then I don't even see how using temp control mode with it is possible?
Any advice would be massively appreciated! Thanks in advance
To put it in temp control mode, I'm pressing the fire button three times and choosing the 'Ni' option. However, I can then only adjust the temperature and not the wattage, which appears on the screen as 75watts. From what I've read online - and, indeed, from the instructions which came with the device - this is too high. It's recommended to only vape with this coil between 20-45w.
I've also found that I get no vape at all when using a low temperature, such as 200 degrees C, in temp mode - but when I up the temperature, I get a burnt taste and sometimes the battery flashes (depsite charge) or rapidly depletes. Although I am also having battery issues in power mode. I'm currently vaping this coil using the only mode where I can change the wattage, at 20w, and am finding the device gets very hot and the battery only lasts a few hours (although this could be due to over-vaping!). I'm using a 18650 battery, as recommended in the instructions.
I'm utterly confused as to which setting to use for this coil and why all the advice is to vape in temperature control mode when you cannot change the wattage on this device? If Kanger recommend vaping this coil between 20-45w, then I don't even see how using temp control mode with it is possible?
Any advice would be massively appreciated! Thanks in advance