Hi all, I recently started using the RBA head that came with my Kangertech subtank mini and since I'm new to rebuilding I purchased 5 pre-wrapped 0.6ohm Clapton coils. The weird thing is that they are rated at 0.6ohm but once I install a coil on my RBA head it reads 0.3 ohm. I heard if you use 2 then it is supposed to read 0.3 but I am only using 1 coil. The vape is quite hot and it also takes 2-3 seconds for the coil to heat up. I'm currently vaping at 32 watts. I'd like run it at 0.6 ohm for a cooler vape, anyone got ideas to what is going on with these coils?
Pre-wrapped Clapton Coils & Kangertech subtank
- Thread starter Snatchman
- Start date
- th_trl_thread_readers 0
- Status
Knowing what device you're using it on would be helpful, I think. Also, have you tried it on multiple devices and gotten the same results?
Clapton coils wire is pretty thick. It can take a second or 2 to heat up depending on what mod and wattage you are using. No clue about why you are getting .3 ohms unless you were sent the wrong coils.
- Status
Similar threads
- Locked
- Locked
