Remove Atty Bridge M401

Discussion in 'M-401/402 "Mini" & M403 Super Mini' started by emus, May 19, 2011.

Thread Status:
Not open for further replies.
Image has been removed.
URL has been removed.
Email address has been removed.
Media has been removed.
  1. emus

    emus Vaping Master ECF Veteran

    Joined:
    Jun 9, 2009
    I always direct drip and don't see any need for M40x atty bridge.

    Anybody experiment w/ removing the bridge?
     
  2. emus

    emus Vaping Master ECF Veteran

    Joined:
    Jun 9, 2009
    I removed atty bridge from M401 atty.

    Can clearly see entire coil.
    Can see scale/gunk buildup on coil.
    Can gently pick at scale/gunk w/ tooth pick.
    Changing flavors is like shifting gears; so quick.
    Put one drop nic liq and get hard TH first puff.
    Flavor is so clean and nice.
    Don't get the sloppy juice mess on the bridge anymore.
    This no bridge M401 atty has easier draw than my other stock M401; not sure if typical yet.
    Wow...love it.

    If no problems arise I will remove bridge from other M401 attys.
    Another advantage of the exposed atty design.
     
  3. emus

    emus Vaping Master ECF Veteran

    Joined:
    Jun 9, 2009
    This is exciting.

    M401 atty w/o bridge draws the same as an unlit analog.
    My unmodified M401 atty draw is significantly tougher than unlit analog.

    Only complaint I have w/ M401 is tougher draw.
    This easier draw M401 is a huge development for me.
     
Thread Status:
Not open for further replies.

Share This Page