rx200

[Kel Gon]

Hi I m new to this thread. Anyone own a RX200 with tfv8? I keep getting either short atomizer or no atomizer signal after using for a week or so. And I just gotten it, sigh. Even my elips have never gotten that bad.

 

[botakchek]

It is a common issue with this pairing.

The 510 pin on the mod has been pushed down too far due to the long 510 pin on the TFV series of tanks. (Actually it's due to the shallow 510 connection of the wismec/joyetech mods.)

You can open up the mod and try to push the 510 pin back up, it's not difficult to do unless you're using the rx 2/3.

Once its fixed, place a spare o ring under the tank so it doesn't have to screw in all the way, pushing the 510 pin down again.

Sent from my SM-G935F using Tapatalk

 

[Kel Gon]

Ah thx but I fixed it. I took apart the atomizer and the coil is not adjusted properly to touch the metal cap that touches the 510 connection.

 

[HULKBUSTER]

Used 2 use this set up but couldn't take it.much longer

Sent from my SM-G930F using Tapatalk

 

[HULKBUSTER]

Tfv8 due to being a juice hoe n 3 batts for the rx

Sent from my SM-G930F using Tapatalk

 

[Kel Gon]

Actually I bought some heatsinks and screw it on top of my rx200, then pull de atomizer on top. This way it will prevent the 510 to go bad quickly as the heat will be transfered to the heatsink instead of the 510 connector.