Snowwolf 218 and Rabies RDA

[mrgriffin]

Hi, I just recently purchased the Snowwolf 218W mod and the rabies rda. This isy first rda and I have a few questions. So the guy at my vape store installed the coils for me and the box they came in reads "Clapton Wire Ohm per coil .5~.6 " and right below that it reads .2/28g. On my mod the ohms sign reads 0.20. I then installed the cotton and Im wondering what wattage should I vape at? Should I vape in a different mode? The mod has 3-5 different modes. Thank you for your help it is appreciated a lot

 

[bsidb]

I would start at 20 watts and see how it taste, not enough? go higher until it taste like you like it

 

[mrgriffin]

At lower watts, it gets no vapor production at all. I'm completely confused, its in wattage mode as well.

 

[bsidb]

wattage mode is fine, bump it up to 30 watts and see if you like it

 

[bsidb]

its not complicated , its what ever you like , YOU, we are all different , there is no right setting or wrong setting, well temp control with Kanthal would be wrong, but is fine in wattage mode, stick with wattage mode for now

 

[Solaire]

I would start at 20 watts and see how it taste, not enough? go higher until it taste like you like it

Yup, i do the same thing start at 20 , go to 30, go to 40, too much ?, go down to 35,,,, and so on.
YOU have a lot of watts to play with so play away and enjoy.

 

[sonicbomb]

Simples.
Start low and increase the power until it's good. Don't forget to keep your wicks wet.