Some help needed with lavatube v4

Discussion in 'Lavatube' started by the_maiden_fair, Mar 19, 2013.

Thread Status:
Not open for further replies.
Image has been removed.
URL has been removed.
Email address has been removed.
Media has been removed.
  1. the_maiden_fair

    the_maiden_fair Senior Member ECF Veteran

    Joined:
    Apr 27, 2011
    Location:
    SD , USA
    When I got it, it worked great (I use standard 510 atty and pump cart set-up). Now I have intermittent problems with atty connection. I read the forums and got some sealed shorty 510 to 510 adapters to use to hopefully fix my problem. Well, it didn't work. I got 3 of them, and none work, will not even show atty resistance, just an F1 message like it isn't even there. I don't understand as it seems so many have tried the sealed adapters and they work just fine on lavatubes with the center pin connection. I was hoping for the sealed adapters to work so I could be assured that I wouldn't have juice + electrical problems. These adapters work on my k-go's just fine, so it is not an issue with them. Am I doomed to only use the unsealed center hole adapters? My center brass pin is clean and springs up and down as it should.

    Thanks for your help!
     
  2. the_maiden_fair

    the_maiden_fair Senior Member ECF Veteran

    Joined:
    Apr 27, 2011
    Location:
    SD , USA
    No ideas from anyone? That is strange.
     
  3. AshJD94

    AshJD94 Senior Member

    Joined:
    Jun 2, 2013
    Location:
    North West, UK
: lavatube
Thread Status:
Not open for further replies.

Share This Page