1. SFATA power breakfast with California State Senator Joel Anderson

    Dear Guest, 

    SFATA are being hosted by California State Senator Joel Anderson this Weds for a "power breakfast". You can bring your input and ideas to him at his El Cajon district office between 9.30 and 10.30. If you're interested and can attend, please visit www.tinyurl.com/SFATApowerbreakfast
     to book a place. Thanks!

    Dismiss Notice

STAND for Drip Tips

Discussion in 'E-Cigarette Accessories Discussion' started by Train2, Feb 22, 2014.

Thread Status:
Not open for further replies.
Image has been removed.
URL has been removed.
Email address has been removed.
Media has been removed.
  1. Train2

    Train2 ECF Guru Verified Member ECF Veteran

    May 11, 2013
    CA, USA
    I want a stand just for tips!
    I have a stand that's working for my mods and my tanks - I just accidentally seem to have developed a little collection of tips...
    And I'd kind of like them all lined up standing...I keep knocking 'em all over when I try to grab one...

    Anyone have a stand just for their drip tips?
    please post a pic or link. And if you MADE one or happen to know - what size hole would I drill to hold a 510 tip?


    [​IMG]
     
  2. sc12

    sc12 Ultra Member Verified Member ECF Veteran

    Dec 22, 2013
    USA
    Wouldn't be pretty unless you made it so but I see a chunk of styrofoam and a bunch of wood skewers or chopsticks.
     
  3. Train2

    Train2 ECF Guru Verified Member ECF Veteran

    May 11, 2013
    CA, USA
    Lol - I was picturing holes rather than "spikes" - but that's not a bad idea!

     
  4. Spike64

    Spike64 Vapemail Stalker Verified Member ECF Veteran

    Feb 18, 2013
    Michigan
    Here's a couple...

    $11.09 Acrylic 3-Tier 30-Hole Display Stand for Drip Tips at FastTech - Worldwide Free Shipping

    $4.47 Acrylic 2-Tier Display Stand for Drip Tips - 23-hole per tier at FastTech - Worldwide Free Shipping
     
  5. Train2

    Train2 ECF Guru Verified Member ECF Veteran

    May 11, 2013
    CA, USA
    Thanks - I did see those...just looking around for other ideas, and maybe something more compact...
     
  6. Mitey F

    Mitey F Ultra Member Verified Member ECF Veteran

    I just took a little chunk of bubinga I had laying around and added holes. Took all of 10 minutes to drill, sand and coat. I try to keep my drip tip selection minimal. No need for a huge collection.

    [​IMG]
     
  7. Train2

    Train2 ECF Guru Verified Member ECF Veteran

    May 11, 2013
    CA, USA
    Ya know - that's probably what I should do.
    I do have probably a dozen that I plan to keep - but I could also use a couple spots for tanks or drippers, etc.
    Want to save me a minute? Do you remember the right drill bit size?
    :)

     
  8. Mitey F

    Mitey F Ultra Member Verified Member ECF Veteran

    I don't... if you want though, I can measure
     
  9. Train2

    Train2 ECF Guru Verified Member ECF Veteran

    May 11, 2013
    CA, USA
    No need - I can do that!
    Thanks! It looks great, too -

     
  10. kristopherdb

    kristopherdb Full Member Verified Member

    my bits were all to big or to small :-(
     
Thread Status:
Not open for further replies.

Share This Page