Tank Ohms

[artymis]

hello,

I have been using a viva nova slim and the v2 clearomizers rebuildable. I like to run 2.8 heads on my tanks, since I have been using my evic and am able to check my resistance level I have noticed that when I put a 2.8 head on there, within a week or two its reading 1.9 and even lower. Is this normal? Does this do it on all the clearomizers?

Thank you

Phil

 

[artymis]

Guess no one has seen this happen before? Oh well, been researching it, but can't find out if this is widespread or not.

 

[RayN]

I'm afraid I really don't have an answer for you. I never use clearos and rarely use an eVic. But with that said, figure out what wattage you like to vape at with the 2.8 heads, then run the eVic in VW mode. It will maintain the correct wattage and the vape shouldn't change as the resistance does.

 

[artymis]

Great thanks, did not know you could do that and it wouldn't change the flavor.

 

[Jet Knight]

hello,

I have been using a viva nova slim and the v2 clearomizers rebuildable. I like to run 2.8 heads on my tanks, since I have been using my evic and am able to check my resistance level I have noticed that when I put a 2.8 head on there, within a week or two its reading 1.9 and even lower. Is this normal? Does this do it on all the clearomizers?

Thank you

Phil

I've had similar discrepancies with Ohms readings with the Vivi Nova heads and I believe its a Viva nova problem. I've used Viva Nova heads stamped at 2.4 but reads 3.2-3.3 on my Provari. Seems like a QC issue with Vivi Novas.

 

[ImThatGuy]

Ohm readings will always fluctuate with usage, debris between connection, dirty connection, etc. Just clean the connections and see what happens.