[CLOSED]
- Thread starter Tbev
- Start date
- th_trl_thread_readers 0
- Status
Looks like some nice thick aluminum . must get one as I don't cloud vape. Well done
Sent from my VS810PP using Tapatalk
Sent from my VS810PP using Tapatalk
Mod looks truly awesome.
Top cap looks really nice to. Always great to see the amazing work that comes from Tbev. No doubt
Top cap looks really nice to. Always great to see the amazing work that comes from Tbev. No doubt
I hear that, once I went to delrin tips I never looked back. Well since we're on the subject. .. I'll be shipping them all out as soon as I can.
Looks PERFECT!!!
Doffy, you keep flashing that gorgeous mod all over the place and I might have to order a bronze for Mark to do!
This must be the most beautiful Bottom-Feeder on the planet. How much does it weigh? I got a wrist problem, so I might not even be able to run a 24 h vape marathon with a mode like this.
finished for anyone hat doesn't follow dready's thread
79 days since i ordered it, but worth the wait
keen to see difference in different alloys, how it conducts and weighs. i think this one is brass 510 pin, and my alum is SS, which may make a difference too
Beautiful Doffy!!! [emoji4]
Sent from my iPhone using Tapatalk with my paws
Mommabird62
Wow I dont think I would ever vape it as I would always be stuck staring at it , that might be the best looking mod I have ever seen.finished for anyone hat doesn't follow dready's thread
79 days since i ordered it, but worth the wait
keen to see difference in different alloys, how it conducts and weighs. i think this one is brass 510 pin, and my alum is SS, which may make a difference too
Ok here's a totally newbie question but I gotta ask.
All the bottom feeder attys I have seem to have the remnants of a screw slot in the positive post pin and I haven't been able to figure out if that's something good, bad or indifferent. Seems like a great way to assure juice leaking out in the 510 but maybe not. What say experts?
duane
All the bottom feeder attys I have seem to have the remnants of a screw slot in the positive post pin and I haven't been able to figure out if that's something good, bad or indifferent. Seems like a great way to assure juice leaking out in the 510 but maybe not. What say experts?
duane
Some atty's are modded that way, the positive pin on the atty is slotted and then drilled, others are just drilled straight through..
Juice flows from the 510 on the mod up through the positive pin in the atty onto the deck on the mod, when the bottle is released juice flows back through the same path...
Leaks normally occur if the the 510 on the mod itself has a leak
Juice flows from the 510 on the mod up through the positive pin in the atty onto the deck on the mod, when the bottle is released juice flows back through the same path...
Leaks normally occur if the the 510 on the mod itself has a leak
Would it be better to not have that slot there? I can't figure out anything good that it can do.
duane
yes... Can't figure out why it wouldn't contribute to leaks.Are you talking about a slot like this?
Duane
if juice escapes, it is captured in the 510... no where to go...
Here is a shot of the 510 in my tmod.... I run the vector I posted above (with the slot) and no leaking...
I also run Vectors on Reo's and Peko's with no leaking... So the slotted positive has not led to leaking
Here is a shot of the 510 in my tmod.... I run the vector I posted above (with the slot) and no leaking...
I also run Vectors on Reo's and Peko's with no leaking... So the slotted positive has not led to leaking
- Status
Similar threads
