[CLOSED]

Status
Not open for further replies.

Tbev

Unregistered Supplier
ECF Veteran
Oct 22, 2013
5,674
12,660
SoCal-Vegas
instagram.com
Just pulled some bronze out of the oven.... and put some gold in.
216623e13e6bf17335cd481b929d9d3d.jpg
8c6d09b852d013e94d6a64094f77f589.jpg
 

distortoblotto

Vaping Master
ECF Veteran
Verified Member
Nov 12, 2013
8,140
47,367
S.F/ Seattle
No, I meant 1.2 ohms with Kanthal and not using TC.

I'm sure you read the exchange between Tom and I on the previous page, I was just a bit confused as to where you came up with the "recommended" 1.2 tis all. I'll tell you what, as you know I like to tinker, I'll toss a 1.2 build in something, give it a whirl and report back if you like. As I stated above my thoughts were aimed more towards TC and with that, I'm sure the SXj chip can be dialed in to whatever vape preference one could want, but in temp control as I'm sure you well know, a 1.2 ohm coil simply wouldn't work. If you are worried about the use of the nickel wire, I do have some Ti wire on the way and plan to play with that and report back as well.;)
 
Last edited:

distortoblotto

Vaping Master
ECF Veteran
Verified Member
Nov 12, 2013
8,140
47,367
S.F/ Seattle
:banana:

I know who that bronze belongs to! It will be rocking smoked plate, black pin stripe, black buttons and this atty with a black drip tip:

mElMqwbl.jpg

Right on INSWVA!! A very fine combo choice indeed! Congratulations, you're gonn'a dig this thing! Don't hesitate to post a flick...:thumb:
 
  • Like
Reactions: inswva
Status
Not open for further replies.

Users who are viewing this thread