Trustfire multi charger settings?

Discussion in 'Battery Issues' started by tnt56, Jan 27, 2013.

Thread Status:
Not open for further replies.
Image has been removed.
URL has been removed.
Email address has been removed.
Media has been removed.
  1. tnt56

    tnt56 Vaping Master Verified Member ECF Veteran

    Joined:
    Aug 30, 2012
    Location:
    Tripple digits half way to home
    I got got a trustfire multi charger. I'm charging aw IMR 18350's, aw IMR 18490's and also aw IMR 18650 and a couple of protected aw bAtteries. I noticed a switch on the side that says 3.0 and 3.6 volts. When I set it to 3.0 volts it goes green (charged). On 3.7 it goes red and after a couple of hours turns green. All batteries are 3.7 volts. Which setting should I use. 3.0 or 3.6 volts?
     
  2. tnt56

    tnt56 Vaping Master Verified Member ECF Veteran

    Joined:
    Aug 30, 2012
    Location:
    Tripple digits half way to home
    Bump for info. Thanks all
     
  3. aziffel

    aziffel Vaping Master Verified Member ECF Veteran

    Joined:
    Nov 10, 2010
    Location:
    nc
    3.6v for 3.7 batteries.They should come off the charger at 4.1-4.2v,over 4.2 is not good for the battery
     
  4. tnt56

    tnt56 Vaping Master Verified Member ECF Veteran

    Joined:
    Aug 30, 2012
    Location:
    Tripple digits half way to home
    Thanks. At least I know my way of thinking was right
     
Thread Status:
Not open for further replies.

Share This Page