Twelve Juno

[unkuser]

I was able to rebuild the coils in the Juno pods. Using the same Nichrome 80 flat wire.

Using a multimeter I checked the stock coils and it read 2.0 ohms. So I built a coil with close to that resistance.

8-9 wraps
2mm inner diameter.

The Juno must have some circuitry to check resistance. Since the 6 or 7 wrap coils would not fire up, which I think is 1.4-1.6 ohms. 8-9 wraps is around 1.9-2.0 ohms and all the rebuilt coils are working. (*I am using a multimeter to measure resistance, so + or - a few ohms)

 

[dansus]

I was able to rebuild the coils in the Juno pods. Using the same Nichrome 80 flat wire.

Nice work, hows the vape?

 

[unkuser]

So far the vape as been great. In conclusion, the Juno is better than the myjet because the pods can hold more juice. A pod can last all day, one thing I need to emphasize is that nicotine salt must be used with the pods.

Regular eliquid isn't satisfying as salt.

 

[unkuser]

Some weird behavior with the Juno battery. Maybe somebody can explain why or what's happening. There must be some sort circuitry or modulation to prevent the battery from working in certain conditions.

1) When the battery is connected to a USB port (charging). All the pods will work. In fact, I think it works better than just the plain battery; there is more vapor This is basically using it as a pass-through device. This method works all the time for all the pods.

2) Some of the pods I thought were broken because of low resistance start working. Then they stop. I have rebuilt the pods at 1.8,1.9,2.0. It seems the lower ohm have higher rate of not working. Not sure.

3) Stock/OEM pods always works. It just the ones I rebuild. Maybe is the material? I find it very unlikely there is timer in the battery because pods starts working again.