Unusual problem with my Therion DNA75

[6steelstrings]

I have my Therion set up for TC hitting 75 watts for 2 seconds then down to 35 watts and the temp set at 500 degrees. When I change batteries and take my first hit it feels like it is pegged at 75 watts and 600 degrees although the screen still shows 35 watts and 500 degrees. If I change the profile to anything else and then back to the original profile it vapes perfectly. The same thing happens if the mod has sat for an hour or so unused, I get a terribly hot vape with a burnt taste.

What do you think it might be?

 

[AtmizrOpin]

sounds like the base resistance is changing when you change the batteries. atty is still warm when you change the batteries so the board reads an incorrect base resistance when the new batts are installed, resulting in a burnt hit/wick. the DNA 75 will not remember the resistance is the battery is taken out. you can lock in a resistance using a profile or plug in a USB charging cable while changing the batts (keeps the board on life support and awake while swapping cells).

an experiment you can try, notice the cold resistance in EScribe's atomizer analyzer when it's vaping the way you want it, then take note of the cold res immediately after swapping cells. Same or higher, after swapping?

 

[Eskie]

Have you tried doing it with Device Monitor in eScribe? Then you can see exactly what the behavior is.

 

[KenD]

the DNA 75 will not remember the resistance is the battery is taken out.

That's one of my pet peeves with the DNA chips.

Sent from my M7_PLUS using Tapatalk

 

[sqonker]

I have a problem too. Mine keeps reading "too hot" changed batteries, tried different atties with different builds but it always will read.. Too hot...

Sent from my SM-N920V using Tapatalk

 

[retird]

Too Hot: The DNA 75 has onboard temperature sensing. It will shut down and display this message if the internal board temperature becomes excessive.

 

[sqonker]

What would make tune board temp become excessive?

Sent from my SM-N920V using Tapatalk

 

[6steelstrings]

I solved the problem. It looks like I may have had a hot leg. I changed coils today and I noticed that the wick close to one end of the coil was burnt. I guess the chip may have compensated for that after I experienced the problem and switched profiles and then back again. I guess that is what was meant by refined resistance. If that is the case then the DNA chip is a darn smart chip.

Now with the new and properly installed coils, I no longer have the problem.

 

[sqonker]

No matter what i do, mine still reads "too hot" and I can feel the mod getting warm. Im scared to use it. Any Ideas?

 

[retird]

Where is the mod getting hot at? Is it hot in the area of the batteries? Are both batteries discharging evenly?