Vamo or what?

Discussion in 'Ask The Veterans' started by gray_world, Nov 27, 2013.

Thread Status:
Not open for further replies.
Image has been removed.
URL has been removed.
Email address has been removed.
Media has been removed.
  1. gray_world

    gray_world Full Member

    Nov 17, 2013
    Reno, NV, USA
    So, looking at the vamo v5, can anyone point me in the direction of something around the same price, that preforms better? I need a PV that I can find for 50 bucks, or possibly less, but want a decent, durable, VV/VW mod. The Vamo is looking really attractive to me right now, but want to know if I could do better. Also asking for recommendations for tanks that preform well on any mods you guys suggest, and on the vamo. Currently using KTS with iClear 30 in 18650 configuration. Any help/advice would be appreciated!
  2. steved5600

    steved5600 Ultra Member Verified Member ECF Veteran

    Sep 7, 2012
    Dallas, Texas
    For the price and my experience with the Vamo V2 I'd say go with the Vamo. Only mod I have had longer is my provari. The new ones solve some of the problem of using atty's like the Mini Davide glassomerizer whic is like the Mini Protank. Won't fit on the Vamo I have with out an adapter. The new ones don't have that problem as you can remove the top cap. I will always have a Vamo. So you know i've had a few mods. I have used the ego's of course. Listed in order of how I like them best first here is what I have: Zmax V3 telescoping, Vamo V2, Porvari V2, K101 Mech and a #19 mech.
  3. dchest02

    dchest02 Super Member Verified Member ECF Veteran

    Jan 24, 2012
    Muskegon, MI
    The MVP is also a solid mod, and can be had for under $50 (link below). I am a big fan of carto tanks. I've never had much luck with clearomizers (Protank, Aspires, etc) A good carto tank setup will cost just as much as the clearomizers out there, and IMO perform more consistently

    Innokin iTaste MVP V2.0 - 101 Vape

    Carto Tank (I have the 25 mm standard)
    IBTanked - Get Tanked With Us!

    Cartomizers (I use 801 Fusions)
Thread Status:
Not open for further replies.

Share This Page