Does anyone know where to get a bottom feed pin for the Velocity Mini? I thought they all came with it, but the one I got from fastech did not.
RDA Velocity mini bottom feed
- Thread starter Chips177
- Start date
- th_trl_thread_readers 0
- Status
The one listed above may work,not sure though.My full sized clone came with the pin,but that pin did not fit my ft mini.I used one from fat daddy vapes,and after installing it,i had to use a dremel to shorten the head of the pin,as it stuck out too far at the bottom.
The Tobeco velocity mini clone, comes with the BF pin
Velocity Mini RDA Clone by Tobeco
Velocity Mini RDA Clone by Tobeco
That's what I thought too since they should all be Tobecos (unless someone cloned theirs) since the authentic is theirs...maybe I got a clone of the tobeco?
I have a Tobeco velocity mini and it came with a bottom feed pin.Who knows who made the one you got from fasttech.Kidney Puncher and Eciggity both sell just the bottom feed pin separate,I would imagine it would fit the mini but can't guarantee it.
Yeah, that's the pin for the full size. I tried that one and it doesn't fit the mini
I'm not sure which model you got, but, check the positive post for a grub screw. From what I understand, the positive post has a grub screw that you can remove for bottom feeding.
Could just order the v2. Only 1mm taller than the v1 mini and comes with the dual purpose positive pin. Remove grub screw to feed, replace to drip...
- Status
