1. Take part in the #WeAreVapor campaign

    Dear Guest, 

    The  #WeAreVapor campaign has just launched and needs your help. This is a massive push to get vapers and vapor businesses visible, and make Congress aware of the Cole-Bishop amendment. It is being organised by the Vapor Technology Association. 

    Please take a minute of your time to take a look at the site to see how you can get involved. 

    Thanks!

    Dismiss Notice

VTR, AGA-T RBA, and Protank II related question...

Discussion in 'AltSmoke' started by Trox.Shawn, Jan 13, 2014.

Thread Status:
Not open for further replies.
Image has been removed.
URL has been removed.
Email address has been removed.
Media has been removed.
  1. Trox.Shawn

    Trox.Shawn Super Member ECF Veteran

    So recently I've purchased a VTR, AGA-T and a Protank. The VTR and AGA-T just arrived over the weekend, but I'm having some troubles now...

    The AGA-T doesn't fit :( - I guess that isn't a problem as much a lack of research...

    The Protank, although works nicely, cannot be tightened down all the way or there is zero airflow. I have to loosen it until the point that it rattles a bit in the VTR "sleeve." How can I correct this. I prefer the protank since I can rebuild them otherwise I'd use the i30s that came with the VTR.
     
  2. rocks82

    rocks82 Supplier Associate ECF Veteran

    Supporting member
    Oct 3, 2009
    Columbus
    Unfortunately, the AGA-T and other RBA's will not fit with the VTR. However, you should be able to adjust the airflow on extender tube sleeve of the VTR. Try taking the threaded ring off and see if that helps out with the airflow issue.
     
  3. Trox.Shawn

    Trox.Shawn Super Member ECF Veteran

    I've put the AGA aside and only use it on my SB from WAAAYYYY back in the day. Great to use it again...

    As for the Protank. I'm not using the extender tube, as I bought the VTR simply because I wanted to keep the tank partially concealed as well as keep the length down with out loosing battery power. I'm currently about to head into the hardware store to find a washer to place between the protank and vtr connection so that I can connect the tank snug, but without losing the airflow
     
Thread Status:
Not open for further replies.

Share This Page