VTR Disassembly

Discussion in 'Variable Voltage APV Discussion' started by Prolix, Feb 6, 2014.

Thread Status:
Not open for further replies.
Image has been removed.
URL has been removed.
Email address has been removed.
Media has been removed.
  1. Prolix

    Prolix Full Member Verified Member

    Jul 28, 2013
    Minneapolis, MN, USA
    I'm having trouble with my VTR, so I wanted to at least poke at it a bit before completely giving up on it.

    I removed the 12 external screws, the bottom plate with battery door, the fire button frame, fire button, the silicon pad under the fire button, the top plate with screen cover (after removing one screw holding a ground wire[?] to the top plate), and a tube lining the battery chamber.

    Large picture is on Imgure at http://imgur.com/SxmbPQM, but here's a small look:


    Has anyone fully disassembled a VTR before? I'm wondering where to go from here. The screen and related PCB in that area seem to be stuck inside pretty well via some means that I haven't yet identified.

    The button PCB pulls away immediately, but has five wires without much slack leading off into the rest of the unit, so that's not going anywhere for now either. But theres nothing other than more brass behind the button PCB anyway -- uninteresting.

    FYI, the external screws are a mix of T-5 and T-6 heads. For the one screw holding that wire's lead down, a Phillips 00 screwdriver fit well.
Thread Status:
Not open for further replies.

Share This Page