Where is the ohm stamp on the SkokTech Aro heads?

Discussion in 'Clearomizers' started by SnowDog, Oct 31, 2013.

Thread Status:
Not open for further replies.
Image has been removed.
URL has been removed.
Email address has been removed.
Media has been removed.
  1. SnowDog

    SnowDog Super Member Verified Member ECF Veteran

    Joined:
    Jun 1, 2013
    Location:
    Springfield, IL
    I just picked up a new SmokTech Aro Pyrex at the local vape shop. I took the heads out to see what the ohm rating is and I don't see a stamp on them. I don't see the information stamped anywhere on the heads.

    Is this normal? Am I overlooking something?
     
  2. Trayce

    Trayce Super Member ECF Veteran

    Joined:
    Mar 28, 2013
    Location:
    Multiversal
    On my aftermarket Aro heads there is also no stamp, but I bought a few five-packs and each 5-pk comes in a small box. The ohms are on a clear sticker on one end of the box. However I'd double-check with a mod or VM.
     
  3. SnowDog

    SnowDog Super Member Verified Member ECF Veteran

    Joined:
    Jun 1, 2013
    Location:
    Springfield, IL
    Unfortunately I don't have a voltmeter or a mod. The heads are the ones that were installed in the Aro when I bought it. I haven't bought any extra heads yet.

    Do the tanks all have the same standard ohm heads in them when new?
     
  4. SnowDog

    SnowDog Super Member Verified Member ECF Veteran

    Joined:
    Jun 1, 2013
    Location:
    Springfield, IL
    As far as I can tell, the tanks come with a 2.4 ohm head installed. I'm not sure if all of them do but the ones I found on websites all say they have 2.4 ohm heads in them.

    I'll go ahead and assume mine is 2.4 ohms unless someone knows otherwise.
     
  5. Pocha

    Pocha Super Member Verified Member ECF Veteran

    Joined:
    Aug 12, 2013
    Location:
    Brisbane, California, United States
    Yeah...I couldn't find a marking on the actual heads...just the box they come in.
     
  6. Trayce

    Trayce Super Member ECF Veteran

    Joined:
    Mar 28, 2013
    Location:
    Multiversal
    ... I can't check the original heads because they long ago got mixed in with my aftermarket heads, so cannot verify the stock heads. And the aftermarket heads are available in a variety of ohms, so, that doesn't help you. 2.4 is probably a safe assumption, but start with lower power and work your way up to the sweet spot, assuming a VV device.
     
  7. SnowDog

    SnowDog Super Member Verified Member ECF Veteran

    Joined:
    Jun 1, 2013
    Location:
    Springfield, IL
    I filled up the Aro last night with some Five Pawns Bowden's Mate. Put it on a Spinner and found my sweet spot at about 3.9 volts. Nice clearomizer. The Bowden's Mate tastes slightly better in the Aro than it does in my Evod and I loved it my Evod. Could just be that the heads are brand new but so far I'm impressed with the flavor and performance of the Aro.

    I'll be going back to the local shop soon to stock up on some replacement heads. I think I'll stick with 2.4 ohm heads for now as I'm delighted with the performance.
     
: evod
Thread Status:
Not open for further replies.

Share This Page