Why is my subtank rba like this?

[CanadiVape]

 

[Ryedan]

The positive post has come off. I don't have one, but my bet is it's got screw threads in the hole in it. If it does the positive post at the bottom of the rba head should be a threaded post.

Take the rba head off the base, stick something small enough to fit into the holes at the bottom and screw the positive post back on. Don't over-tighten it.

If there are no threads on the positive post it's a interference fit and it will a bit harder to repair.

 

[CanadiVape]

There are no screw threads that I can see. It's just a loose fit on the attys base. It's just really strange and I'm not sure if I should just get a new one or not. It's a v1 and people seem to prefer it for the juice holes are in the bottom. But yeah, as far as I can tell there's no way to attach it back on.

 

[crxess]

Press UP on your center pin and thread it back into the Positive post bracket.
It got loose and backed out.

Remove Deck from Base
Push pin into place
Set Plate over pin
* Make sure insulators are in place - bottom/top
Screw tight
Refit Coil
Wick, assemble, test read, wet, fill and vape

 

[CanadiVape]

Press UP on your center pin and thread it back into the Positive post bracket.
It got loose and backed out.

Remove Deck from Base
Push pin into place
Set Plate over pin
* Make sure insulators are in place - bottom/top
Screw tight
Refit Coil
Wick, assemble, test read, wet, fill and vape

I feel smart.