Wismec Reuleaux 2/3: having a hard time fitting the two battery cover

Status
Not open for further replies.

Pukkita

Full Member
Sep 3, 2015
24
32
52
Hello,

Just received my Wismec reuleaux 2/3 today.

I really dig the RX 2/3 in two battery format, really ergonomic and lighter than the cuboid with the same two batteries while on-the-go.

However fitting the two battery cover (instead of the 3 battery cover) is turning out to be a nightmare; while the cover is properly placed and fits seamlessly, I cannot make the bottom latches to "click".

I have managed to make it "latch" properly just once in about 30 times I've tried.

Any tips or tricks??
 

Pukkita

Full Member
Sep 3, 2015
24
32
52
thanks for the suggestion, hightech...

I have VTC4's and Panasonic NCR18650B; At first I only was able to latch with the VTC4, but today (3d cover change) I was able to latch it to click with the Panasonics.

I measured and the diference in OD between them was 0.10mm.

Definitely looks like tolerances are rather tight and the cover needs some use to get to "shape"
 
Status
Not open for further replies.

Users who are viewing this thread