Modding the cup using the diamond point bit that I referenced earlier in this thread, makes it easy to modify the plastic piece as well. IF you widen the channel to the same diameter as the bit, It wicks much better. As Zoranth said "It vapes like a locomotive"
Poppa D, I haven't noticed the fine particulates that you describe, I will keep my eyes out in the future though. With regard to the material, their MSDS sheet lists the finest particulates being 3-7 microns. (Too big to get into you alveoli) With respect to their findings where they were actually introducing particles into a lab rats lungs (bypassing the upper respiratory tract, which is efficient at removing all but <1 micron particles) it didn't cause the same problems that other silica products did (like fiberglass). The facts are there, it isn't good to breathe any of this stuff we use for wicks. Largely this one is very inert compared to others I have researched.
Poppa D, I haven't noticed the fine particulates that you describe, I will keep my eyes out in the future though. With regard to the material, their MSDS sheet lists the finest particulates being 3-7 microns. (Too big to get into you alveoli) With respect to their findings where they were actually introducing particles into a lab rats lungs (bypassing the upper respiratory tract, which is efficient at removing all but <1 micron particles) it didn't cause the same problems that other silica products did (like fiberglass). The facts are there, it isn't good to breathe any of this stuff we use for wicks. Largely this one is very inert compared to others I have researched.
Last edited: