Zna 30 amod

[Albert Corales]

Hi,
I purchased a clone zna 30 amod about 2 weeks ago. I have an efest 18500 1000 may 37v, and an Kangtec Nano with a 1.2 coil.
My question is this: Every time I go to hit it, it takes a while to fire up and most of the time I get a check battery sign on the screen and yet I have just finished charging the battery. I have tried different batteries but it still isn't working. Can anyone help?

 

[roxynoodle]

I believe that battery is rated at 10.5A, though Efest tends to exagerate specs. So it should work with a 1.2 ohm build.

I have the same mod, but I've only used AW 18490 batteries, which are 18A batteries. I've had the mod for 11 months with no issues.

Do you have another atty you can try on it? Is your 510 pin adjusted properly to make good contact with the atty?

 

[DavidOck]

Perhaps a good cleaning of all the mod contacts might help. A poor connection on either end of the battery might come across as low voltage.

 

[USMCotaku]

The zna mods check battery lag, and will give you that warning if there lag is excessive.... Is the battery new? I would try a different battery. If a different battery fixes the issue, but the over you are using is "new" from a shop, I would try to get them to swap it out
Sent with one hand, the other is busy vaping.