Checking the coil on the Ohm Meter. Shows 1.6 Ohms exactly. I wanted a 2.0 Ohm coil, and rebuilt the coil using a 3/4 wrap and got exactly 2.0 Ohms.
Upside down, showing the 510 connection and the eliqued fill screw. Remove the screw and use a needle nose bottle or Ucan. Like the Kayfun 3.0, and does not require the plastic fill needle as does the Kayfun 3.1.
The is the finished Kayfun. Chose all metal this day, on my second 2.0 Ohm coil build, as I was having a bit of leaking with the clear tank tube. The metal has not leaked. What a tank! Sitting atop the Siam Mods Tank Holder.
Threw the Kayfun on the Kir Fanis eVic to hopefully show the 2 Ohm resistance, using 7 Watts. Great first build and vapes nice. Without air control like it's big brother the 3.1, I found the draw a little too airy and wish I had bought the Russian 91% which is identical but has the air flow control and half the cost. Marvelous piece of engineering and great vape.
Checking the coil on the Ohm Meter. Shows 1.6 Ohms exactly. I wanted a 2.0 Ohm coil, and rebuilt the coil using a 3/4 wrap and got exactly 2.0 Ohms.
The remaining tubes are added, this day all metal, and then the top and mouth piece (drip tip) are added. The Kayfun is ready for juice now.
the top of the chimney is added, as is the first tank ring.
At this point, I added some eliquid. It allowed me to push the wicks down into the chimney tube, but not "stuffed," which could block juice flow. Also, remember to keep the coil above the air flow chamber.
Bill's Magic Vapor

Checking the coil on the Ohm Meter. Shows 1.6 Ohms exactly. I wanted a 2.0 Ohm coil, and rebuilt the coil using a 3/4 wrap and got exactly 2.0 Ohms.

Leave a rating
Follow Add bookmark
There are no comments to display.

Media information

Album
My Kayfun
Added by
Bill's Magic Vapor
Date added
View count
338
Comment count
0
Rating
0.00 star(s) 0 ratings

Share this media

Top Bottom
Forums
Products
Vaping.com
Star Suppliers
Blogs
Menu