Recent content by BJ43

I agree!!!!!!

Lol, Mike....Moved on to bank tellers, cute and they know where my charms lie. My accounts....

Clouds

Semi retirement has made me lazy. Mostly vaping the nautilus and atlantis TC, but I finally had to see what all this cloud busting was about. I wrapped a dual coil 12 wraps each of 26g NI at 3mm and hit it with 80 whatts, 430F and .09ohms on a 200 DNA. WOW

The beginning.... Many years ago.

Amazes me that this thread still exists. Over three years. LM2596 or as I like to call it, the "Model T of VV vaping.

Just too much for an old man, LOL, Supermarket, carwash, banks, facebook, whatsapp, twitter, instagram, line, tango. And then there is golf and the wife. Be back later, going to the supermarket...:evil:

OK, I am back

TBA = tobacco absolute

Golf widow.......;)

Un muy buenos dia a la bella Tibs....;) Gotta go, golf at 10am.:)

In order of preference on the DNA40. IMO Drippers a 10 Taifun a 9 Kayfun or Russian with horizontal wick a 6 Kayfun or Russian with vertical wick a 5 Genies a 2 As to wire I have tested 26 to 34g NI200 My preference is 34g double twisted 3 to 4mm dia coil at .1 to .2 ohms.:) This...

@ Sniffle. most beta testers did not have much luck with SS mesh or rope. Like putting a lawnmower engine in a Ferrari. Using very low resistance wire on a SS wick is also complicated by easy shorting. SS kinda defeats the purpose of this new technology. But go for it, you may find a setup that...

Basically there is no such thing as non resistance wire. Nickel NI200 is used because it has a very constant ohm increase as it heats. So you start with a reading of the ohms at room temp and as it heats the ohms rise, this measured ohm rise is then controlled to maintain a peak F temp.

32g nickel coil at .19 ohms on a genny with Ao wick and hemp booster.