Ok here is how you "mod" a 905:
Standard 905:
Dissasembled, and dremel sanding wheel you need:
Sanding the body out:
There is only approx 1/2" of material that needs to be honed out:
Top piece, the grey plastic lining needs to have 1/4" removed from the bottom next to the contact point:
Top piece after rubber has been cut out with an xacto knife:
Now once all pieces have been modified, the 2 CR2 batteries will go in and make contact with the top contact point.
Thats it...
Hope this helps
Dan
Standard 905:
Dissasembled, and dremel sanding wheel you need:
Sanding the body out:
There is only approx 1/2" of material that needs to be honed out:
Top piece, the grey plastic lining needs to have 1/4" removed from the bottom next to the contact point:
Top piece after rubber has been cut out with an xacto knife:
Now once all pieces have been modified, the 2 CR2 batteries will go in and make contact with the top contact point.
Thats it...
Hope this helps
Dan