Search results

  1. nj1001

    Starting with dripping

    Or better yet get any more standard RDA than you were thinking like Kent said, spin up a micro or nano coil and put a pea-sized dollop of cotton underneath the coil while making contact, drip a flavor and switch out the cotton for another flavor. You'll get great flavor and vapor doing that and...
  2. nj1001

    Am I "safe" with this RBA setup?

    Yes its safe. The Vape2Safe fuse will ensure you're not going to blow up and will automatically cut the power if its too much for the battery. So, with your ohms calculator you can see 1.3ohms @ 8w = 3.22V & 2.48A all of which is perfectly safe. Try it at 15w and see the difference. If you...
  3. nj1001

    Can juice steep too long?

    I hate that sometimes my favorite flavors get muted from over use. I have had batches run a little muted from time to time however. I usually find one or two I love and over chain them all day every day sometimes for a year or more. I notice not getting the same flavor out of them until I...
  4. nj1001

    What are your "must have" big bottles of e-juice (30ml or bigger)?

    Halcyon Vapors: -Dragon Ch'i -Cran Ch'i I can't get enough and alternate between the two chain vaping tank after tank all day ever day.
  5. nj1001

    New Projects by Atmomixani

    Any more updates?
  6. nj1001

    Greetings from Cape Cod…NOOB first post seeking advice

    Also, search around different sites for ego twists if you want and you'll find one anywhere, but the HH357 long barrel atomizer is only sold at avidvaper.com Everyone's palate is different and there are hundreds of different juice vendors. Nobody has tried every juice from every vendor and...
  7. nj1001

    Greetings from Cape Cod…NOOB first post seeking advice

    Buy an ego twist, a drip tip & an hh357 from avid vaper and some decent juice. That should set u up with something adequate without wasting money and time researching. Once you have that you will find it satisfying and many vaping veterans would agree. Then if you dig it and want something...
  8. nj1001

    Introducing Futura - The Modular DNA 20 APV by NexgenVapor[ISSUE]

    I dunno. Look it up. I suspect it probably will since it seems to be a topically applied logo.
  9. nj1001

    Cotton Wick Pre-Soak

    All I ever use is 28 gauge after buying various gauges but I don't use a kanger, instead I'm all rba, rda or kayfun. The advantage of 28 gauge is it's do thick if making micro coils they'll last a month and all that's needed is to replace the cotton every few days (which should be done when...
  10. nj1001

    Introducing Futura - The Modular DNA 20 APV by NexgenVapor[ISSUE]

    Why don't you use a scotch brite pad to remove the 91%'s finish leaving behind SS? I've read it's pretty easy to do. I've been holding off on that because I want to see how it looks with my futura in titanium finish.
  11. nj1001

    Introducing Futura - The Modular DNA 20 APV by NexgenVapor[ISSUE]

    When I first saw this page starting with "I got mine Wednesday" I thought it was a joke about the futura but then put 2 n 2 together. So, to continue with the off topic topic & to throw in my 2 cents, when deciding whether to buy a kayfun lite or the 91%, I settled on the 91% as its the same...
  12. nj1001

    Dragon coil v. Micro coil?

    I'd caution against serious sub-ohming below 0.8 ohms personally. But yeah. Basically a nano is coiled around a pin, needle or something smaller. I think there's a chart somewhere on the forum with strict classification guidelines for micro, nano, etc. coils based on their inner diameter and...
  13. nj1001

    Cotton Wick Pre-Soak

    I second that. I have heard of rinsing/boiling cotton balls & yarn but I think that pre-soaking a wick in juice would make it more difficult to manipulate when you try to install it into your set up. There's no need for that.
  14. nj1001

    What is a good, small tank/clearomizer?

    I'd like to try the AL-1 but thats probably not what you're looking for and if it is good luck because they're sold out of everywhere. But it is a really small genesis atomizer.
  15. nj1001

    Which High end mod to get?

    The nemesis you have is known by many to be one of the hardest hitting high end mechanical mods out there and it's silver contacts are plated and replacing them is easy and relatively inexpensive. The maintenance required for silver contacts (plated or solid) is really just to periodically buff...
  16. nj1001

    What happens if you overdischarge a battery?

    Lithium 18650 explosion - YouTube It should also be noted that flames from Li-ion battery explosions often cannot be extinguished with water. I personally find sub-ohming below 0.8 to be just dumb, especially if you haven't done your homework, don't have adequate health insurance or care not...
  17. nj1001

    Why is it burning?

    Voltage at whatever ohms issue or the atty is dry & burnt. Is there a chance it could have gone off (button pressed without you realizing it in a pocket or something for a little bit? That could cause the atty to burn and the only way to get rid of the taste of burning mannequin would be to...
  18. nj1001

    What CVS Cotton should I get that DOES NOT require boiling.

    So does the boil or not to boil difference really just boil down (no pun intended) to 5-10 puffs before they're equivalent flavor-wise? I've heard some say boiling for 30 mins in sterile water followed by sterile water soaks, etc.
  19. nj1001

    Introducing Futura - The Modular DNA 20 APV by NexgenVapor[ISSUE]

    :vapor::rickroll::thumb::vapor:
  20. nj1001

    Alexander Mundy's Magic Twisted Ribbon

    Thank you so much. I just ordered these which came out to about $21 with shipping.
Top Bottom
Forums
Products
Vaping.com
Star Suppliers
Blogs
Menu