Search results
-
xvostick clone any owners?
If your looking for just a wattage mode side by side. I bought this from 3f and used it for a week while I waited for xvosticks to land. Zero issues with it but only 35 watts and no tc. My son in law has been using it daily for about a month with out any issues and it's less than 34 bucks -
xvostick clone any owners?
If you set temp to off it will display voltage all the time but like others seems to work the same either way -
xvostick clone any owners?
Up to this point it's been very civil here because the posters have not got into the merits of right or wrong as far as counterfitting goes. There are numerous threads where this is and has been debated here on ecf. I prefer not to get into that debate. I will continue to post here giving my... -
xvostick clone any owners?
I can't compare only have 2 clones that I feel are well worth the 50 bucks each I paid for them. They are the only devices I have used since they landed. Warm mod I attributed how I hold them wrapped in my hand. I did not consider them too warm. The display I felt was top notch. Very bright... -
Itaste SVD died, what's a good replacement?
Alot of us have moved onto box mods. At first it might not feel right but give it time and you will not miss a tube mod style. Alot of good priced mods out there -
xvostick clone any owners?
When you change atties loosen the battery cap to break the connection it will reboot and ask if new atty....seems to work better -
-
xvostick clone any owners?
oops messed up quotes again.... No dim on screen but shuts off at 60 seconds -
xvostick clone any owners?
You can set temp to off if you want to get it out of temp mode. It seems to work the same either way but will show volts if you set temp to off -
xvostick clone any owners?
Yes I already tested that nothing below 1... figured even though on boot up its says evolve dna it is not -
xvostick clone any owners?
I THINK what we are seeing with that message " ohm too high" is that limit of the mod is probably 6 volts. Ohm's calculator says a 1.1 ohm coil running at anything over 32 watts is 6 volts. When we are running a .9 ohm coil you can vape up to 40 watts before you reach 6 volts -
xvostick clone any owners?
Xvostick clone board size.... 2mm wide by 3.5ml long (don't know who makes it) -
-
xvostick clone any owners?
The 510 plate threads sticking thru the top half. I unscrewed the 510 plate and greased the threads with electric grease. Ohms staying steady now. Also don't worry about any juice leaking into the electronics don't see any chance of juice seeping in -
XvoStick users?
The top end (clone) you can see where the threads from the top 510 plate come thru the top end. I unscrewed the 510 plate and then used electric grease and reinserted. Ohms staying steady. I would also say I doubt any juice could seep thru and get into the electronics -
XvoStick users?
Ahh thanks for that info. Maybe both have the same issues... Maybe's it's china copy of the dna chip is too good and it's a chip problem. Or the later... I know when I fiddled with the 510 plate it worked much better. What I can see is the plate is threaded into the top end end and it is painted... -
Remove hot glue
So not advised on the screen? Never mind i was able to pull glue off...thanks- mgmrick
- Post #3
- Forum: Modding - Handcrafted Gear
-
xvostick clone any owners?
The threads that my atties screw into are fine. I want to remove the 510 base to clean the paint off for a better ground to the mod