Search results

  1. Cowboy192

    RDA Problem with Magma clone (doesnt show ohms)

    I agree, I build single coil on mine and do one coil over the air hole then use the ring to block the air hole on the opposite side, And yep it is the 510 being too short to make contact, but you can't leave the screw loosened as you'll get a poor connection not sure what to suggest
  2. Cowboy192

    RDA Problem with Magma clone (doesnt show ohms)

    Try putting an adapter between the istick and the magma, for some reason my other halfs istick doesn't read my magma but it works fine on my ipv2, I think the 510connector on the magma might short on the Istick
  3. Cowboy192

    RDA How Many !!

    Two, and one of them rarely gets used, a plume veil that lives in my vape chest and a magma that's set up with a single 1.4ohm coil and rayon wick for flavour, it gets used for testing my diy juice or dripping juice that I chuff on now and then, don't really feel the need to get any more unless...
  4. Cowboy192

    So simple, why didn't I notice before?

    Yeah, I got for a heat flux (or what ever it's called) of 180 Gives me a nice amount of Vapor and loads of flavour I do now and then, I never win lol
  5. Cowboy192

    At this moment: Which Nicoticket eLiquid are you vaping? #2

    Cls here too, I got this bottle back in November and to be honest it was rather meh, at the time I was chuffing away on a well steeped bottle of bryces and the cls didn't impress me so I chucked it in to the back of my vape drawer and forgot about it untill a couple days ago when I pulled it out...
  6. Cowboy192

    Lemo Airflow

    Not sure on the sub tank but I feel like my lemo has almost no restriction on air flow when wide open, kinda like sucking air through a wide straw
  7. Cowboy192

    So simple, why didn't I notice before?

    Ok so I have a magma, a lemo and a kayfun each normally built with single coils, using 28awg anywhere between 1.2 to 1.8ohm (my lemo is pretty much always rocking a 1.4, and the others I change with each build, but I have a habit of forgetting what power setting I ran each at..... untill I...
  8. Cowboy192

    Why do all of my DIY mixes suck?

    Honestly, the ability to go to 0.01g would be more than enough but I'm Mr ocd and love gadgets, why get a good gadget when I can have the ultimate gadget lol
  9. Cowboy192

    Why do all of my DIY mixes suck?

    Scale is good, I'm trying to find one that goes to 0.001 grams, but syringe is pretty good too
  10. Cowboy192

    Why do all of my DIY mixes suck?

    Short answer to your question of why everything you make sucks?....... Because your starting to learn something new and it takes time and practise to become good at things, I've been doing diy for a couple months now and I'm starting to get some good results, I have a mix I call sucker punch...
  11. Cowboy192

    Best uk e-juice brand ?

    Yeah I use Myepack too (normally for mods and I chuck a couple packs of coils on my order too) really good prices on their site
  12. Cowboy192

    Best uk e-juice brand ?

    Just checked their website, prices are way higher than Zapp, pack of nautilus coils being £3 more than Zapp, nowhere near the choice of juice either (Zapp stock some stunning juices) and they don't seem to have the same range of hardware either, (zapp carry pretty much every aspire and kanger...
  13. Cowboy192

    Sigelei Mini 30W

    Cheers, just wanted to make sure, don't think she will use hers in dc-dc mode as she just runs nautilus tanks, I might try it with my rta/rda's
  14. Cowboy192

    Sigelei Mini 30W

    About to go order a pair of these (one for me one for my lass) can someone just clear up if it does have step down ability (it can reduce power below what the batteries charge level is) as my lass is getting a bit fed up with her is tick running too hot when fully charged
  15. Cowboy192

    eJuice Me Up - eJuice Calculator

    I feel your pain there, same for mine until I built a clone drive I did a fresh install of windows and all my software then ghosted it onto a second hard drive that lives in a case so if I need to do a rebuild it is a ten min plug and play job
  16. Cowboy192

    eJuice Me Up - eJuice Calculator

    I used to do I.T that seems more of a problem with your PCs and install of windows, I've run the calc on win 7,8 and 8.1 with no problems, but I have had other software do that Adobe Lightroom and Photoshop,it was down to a corrupt windows install
  17. Cowboy192

    eJuice Me Up - eJuice Calculator

    Would be a damn good call to do it as an app! Would save me having to mix near my pc lol
  18. Cowboy192

    smooth or vape wizard?

    I wouldn't say I'm patient, it's just that I have other diy recipes that work really well so I have a good half litre of diy juice and probably another half litre of store bought juice (nicoticket, bryces and chefsvapour) so I'm trying to get through them too, means I don't need to rush onto my...
  19. Cowboy192

    You get what you pay for?

    I don't go by price, I go by reputation, reviews and most importantly personal taste, I've had some expensive juice that I really couldn't vape, but then I've had the same with some cheap ones too, just a word of warning though, if your new to vaping don't overstock on any one juice or you may...
  20. Cowboy192

    How Do Buy/Get Your Ejuice??

    Let me know next time your heading Wales way, I'll guide you to a good store, American brands carried, Testers in nautiluses and kanger equivalents, But yeah still about £5 per 10ml but that's for the better quality juice, their cheaper ones are less but I don't bother with them
Top Bottom
Forums
Products
Vaping.com
Star Suppliers
Blogs
Menu