So I have my first problem with the bolt I went to grab it and take a pull the other day and it did this weird pop pop sizzle then nothing I opened it up to find that somebody had put my battery in upside down (cough cough my wife) the device got very hot and the hot spring collapsed and is...
It is a pain to rebuild but I finally just started buying prewound wick and wire from NHaler and add 1-2 extra wraps and I am vaping at 6v and it is amazing. As for holding the liquid I just drip a ton into it and I haven't had it leak yet, there seems to be a well and the wick absorbs most of...
This is true I drive truck pulling 3 trailers and the hardest part is if something goes wrong with your atty or you spill juice and all around "Fiddling" as was stated above. What I have done is switched to tanks while driving and atty's while sitting. The problem with a pass through is the...
I did a full rewire of mine and changed the connector and the switch as well. I posted it here http://www.e-cigarette-forum.com/forum/modding-forum/317133-rewiring-bolt.html
I can't seem to find a PV stand and the one I found is sold out HERE. The only thing wrong with this one is it only holds two pv's. Are these just candle holders or does someone sell PV displays?
Ouch this is the state I work in I drive truck to Bismarck every night. You probably have to be a ND resident to have any say in this don't you? If it happens then MT will be next, this is getting too close to home.
So then what are these:
Flash Throat Hit Enhancer - One Stop DIY Shop Store
VaporChase Review - Throat Hit Plus from The Vapor Pro - YouTube
VaporChase Review - Diablo Loco from Totally Wicked - YouTube
I have been at this for over a year and it seems that every time I get it figured out something changes. My original starting out after the super cig was an ego-t. I found the atomizer to be a joke the tank system a bigger joke and got frustrated. Then I began lurking around the forums and found...
Next solder your second wire to the battery connector.
After that push your pin with the wire back into your connector and run the wire through the switch hole do the same with the battery connector then attach the wires to your switch.
At this point you can now test and make sure it works...
First I would like to thank Nomoreash for explaining to me how to do this so all credit goes to Nomoreash.
I had read alot about how the bolt had razor thin wiring and could probably not handle 6v vaping, so I really wanyted to change the wires. I am not the most mechanically inclined person...
I bought my first sealed bridgeless atomizer thinking that a sealed atty=no leaking this does not seem to be the case. Was I wrong or do they still leak, if so then what is the purpose of a sealed atomizer? As always any help is appreciated.
Yutty
First let me say I have worked for UPS for 4 years now so thank you for saying you would rather use UPS/FedEx rather than USPS. I myself cannot stand the postal service I had a package the other day that said it was delivered at 3:32 such and such day and it didn't show up to my house until 2...
I had this happen blowing some liquid back into my atty off the drip tip it does burn just a bit LOL especially higher nic I did it with 5mg once and it just blurred my vision for a second or so but didn't really burn.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.