Search results

  1. dimo

    Traveling With Filled Tanks?

    You should be ok. The only time I've ever had problems with spare filled tanks is on airplanes. The pressure change on takeoff and landing can cause major leakage.
  2. dimo

    Can VS rDNA 30 be used while charging?

    Yes to all above. Nothing special needed to know for safety.
  3. dimo

    KFL+ Too Harsh, Reduce Nicotine or Go Max VG?

    I dropped to 6mg from 12mg when I got my first rebuildable. 12mg was too harsh. On my kfl, 6mg hit as hard as 12mg in a protank. I recommend dropping down the nicotine.
  4. dimo

    Stingray X or Nemesis

    I have both. The stingray x is a much better mod. Floating 510 pin, all copper inside, shorter switch, lower voltage drop.
  5. dimo

    Is Provape in danger of becoming like Blackberry?

    I believe the dna40 uses a 32-bit arm processor.
  6. dimo

    RDA Best RDA for Mouth to Lung?

    I'm strictly a mouth to lung hitter. I have both a magma and kayfun lite and like them both. I run my kayfun wide open with the afc screw completely removed and the magma in single coil mode on the smaller setting. The draw on them is about the same setup like that. I have heard that the v2...
    • dimo
    • Post #10
    • Forum: RDA
  7. dimo

    Rebuildable Recommendations Lemo, Kayfun etc

    My kayfun lite has the best flavor of any tank in my arsenal. That being said, it's also a gas guzzler compared to my clearomizers. I'm not so sure that any RBA or RTA will use up less eliquid than a clearo, especially if you plan to use 28awg wire.
  8. dimo

    Provape - A New Respect

    I work in the industrial electronics repair industry. While it would be more cost effective for them to simply swap the boards, they will learn valuable information from the bad ones when they do component level repair. You can test your boards all your want and run all kinds of simulate tests...
  9. dimo

    THE BEST nemesis magnets

    I have the ones from fat daddy vapes. They work great!
  10. dimo

    Going from Kayfun to a Dripper

    If you can handle 24mg in a kayfun, you'll probably be ok with it in a dripper too. On standard coil stuff like protanks I used to use 12mg, then halved it to 6mg when I switched to my dripper. Still use 6mg now that I have a kayfun. For me, my kayfun tastes nearly identical to my dripper...
  11. dimo

    Hcigar russian clone questions

    Not sure how you hold it when filling, but holding it upside down when filling from fill port will prevent flooding and leaking from the air hole.
  12. dimo

    Help with Kayfun O-ring

    Are you sure it's not there? The hcigar version has a captured o-ring compared to a loose one for the original.
  13. dimo

    Whats Your Favourite Ohm Number?

    I do a 6 or 7 wrap micro coil on a 5/64 drill bit with 30 awg kanthal. About 1.5-1.6 ohms. Use this in my igo-l and my kayfun.
  14. dimo

    How long does your coil/wick setup last?

    In my kayfun I typically rewick and change flavors every 2 full tanks. About 8ml or so.
  15. dimo

    26650 mech mods

    These guys make one The Big Nasty PRE ORDER I'm sure there are others too.
  16. dimo

    Side by side pics of KFL+ and EHPro clone

    Yep
  17. dimo

    Side by side pics of KFL+ and EHPro clone

    I have the ehpro clone as well. Mine was just like yours, except mine does have the markings on the bottom cap like the real KFL+. Mine isn't blank like yours. I also run the plastic center piece with no o-rings. Works fine, no leaks. I picked mine up last week from a local b&m store for $49...
  18. dimo

    Best LOOKING mechs for Kayfun 3.1 SS clone

    At my local retailer I put my brushed kayfun clone on a nemesis clone they had to see what it looked like. It looked awesome together.
  19. dimo

    Chicago decided to ban E-Cigs now

    (EDITED) I agree with Visus. Vapor leaves a fog that sticks around for a little bit. It doesn't just disappear into nothing at a rapid clip. I can easily make my living room look foggy if I chain vape hard enough. If there's 2 or 3 of us my living room will look like a fog machine went off. And...
  20. dimo

    Kayfun 3.1 gurgling/low vapor production problems

    Double check the ohms. I'm thinking it should be closer to 2.5-3.0. You may have a minor short somewhere. What device you have this attached to?
Top Bottom
Forums
Products
Vaping.com
Star Suppliers
Blogs
Menu