Remove the rubber o ring from drip tip. Wrap some thin wire or plumber's tape and reinstall the o-ring. Alternatively, locate thicker o-ring at local hardware store?
That should help.
Cheers.
1. I keep multi EVOD types for different flavor. Keeps cleaning to when I need to clean the coil instead.
2. Soak in hot tap water rinse and repeat. Dry burn and rinse again. re- assemble. Done!
Some use everclear or vodka to soak. I find that is not necessary.
Hope that helps.
Sounds as you still have no connection on the center pin (with Kayfun). See if you can un screw the center pin of kayfun just a little and try again?
Also do you have multi meter or a way to test the kayfun ?
And congrads on getting the Kayfun. I'm heading that way too.
Good luck.
Try a protank 3 Bottom dual coil?
If you like that may be go up to Kayfun or russian.... after that. It's a little bit high as far as learning, but I'm heading that way.
Good luck.
I applaud you and others that make use of perfectly good tool that performs well beyond what it was intended and it's cheap as chips!
Now If I can find other items such as mech mods in the price range? Can I dream?
Cheers
Get yourself a muliti meter.
Using a bad battery can spell big trouble for you. Could be the charger or the battery.
I would get myself a known good battery and be done with it if I were you. And remember to dispose of the battery correctly.
Answer to your led question, RED - charging...
Hey Bad! Thanks for correcting me and stopping me from making a mistake......
I have IMR battery but no sub ohm- ing (in 1.8 ohm range) and very happy with it.
Again, thank you.
Cheers
I agree.
I would use that battery in a flash light or regulated mod such as VAMO or similar. Alternatively ......
also with a kick in a mech mod.
Cheers.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.