Looks awesome right now. Check this stuff out, there are similar products for guns that are DIY and you cure them in the oven. Very durable and self lubricating so the door slide will hold up well.
Cerakote Coatings
edit: Looks like there is a place in Lansing to get it done, Pierce...
Unflavored juice is in my regular rotation. Sometimes it just hits the spot when nothing else does. You say a lot of the juices you have are too strong, you can dilute them with the unflavored and still have 24mg juice that you can vape. I'd try small batches at first to find the right ratio...
They'll all break the bank eventually but if you really want to go that route be sure to try a couple of 306 attys. You'll need a 306 drip tip to go with them. I always liked them better than 510 attys.
Nobody mention House!? Loved that series and Boston Legal two of my favorite network shows. Just about all of HBO's shows, even Sex in the City. Got hooked by my wife watching it. Some oldies I liked Kojack, Starsky & Hutch, Hillstreet Blues, Baretta.....
Would you be more inclined to make them if the button was threaded, say 1/4-20? It would eliminate the need to be fitted. I might run a die on one of mine and see how it threads.
You need to slow down and do some reading. Fat wire and low resistance can lead to unwanted results if you're not careful. I hope you are using good batteries. I'd start in the RBA section. Be sure to check out the Micro Coil threads. You can get sub ohm results with higher resistance coils...
I like to rebuild them myself. I was nervous first time but figured I could send it in if I screwed it up. It was even easier to do than I expected. I didn't save much money doing it myself and maybe only a day or two shipping time. But I figure I saved some of Rob's time that could be used...
Reminds me of Willie Landum, Fishing Guide to the Stars. The names of his baits and lures always cracked me up. If you've never heard him check some of these out.
Willy Landum Fishing Guide.... To The Stars
The IGO-L works nice once setup but its a pain to setup. There are no holes in the posts to put the wire through. You have to wrap it around the screw and tighten it down. This almost always pulls on your coil and messes it up. The IGO-S is smaller but easier to work with because it has holes...
Well switched to Ekowool today. Went with the skinny stuff doubled and pulled through the micro threaded on a piece of wire. Quick and easy and getting really good results. Might be my favorite setup so far. Threw a black Smok Mini in the cart when buying batts, was a PITA to convert to BF but...
You've also got to keep batteries for stacking paired. They need to be balanced in their charge too. If they aren't balanced and in series, when you close the circuit with the fire button the higher charged batt will try to charge the lower one. If the difference between the two is big enough...
I decided to stop buying used ones and then a 2.1 with a Hornet showed up in Classies. Another 2.1 was gonna be my next purchase and I've been wanting to check out a Hornet but just couldn't pull the trigger for retail price. Best case I got the atty free, worst case for the price of a rebuild...
The first thing I thought of when I read your post- I bet he's vaping Pluid. I've had it swell orings too. I think it's the citrus oils in it causing the problems. I have a Reo dedicated to it and I use the RM2 with it because the cap screws on rather than held on with orings. Haven't had...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.