Search results

  1. atroph

    WISMEC Reuleaux RX200 TC

    It may or may not be a 510 issue. I believe if it goes to deep sleep it will check the coil upon startup and if it is higher than it remembers (still warm/hot for instance) it will ask new/same. IMO best way to alleviate this is to lock it in and it will never ask new/same. Just remember to...
  2. atroph

    The Flavor Apprentice Flavoring Thread

    What is a good starting point for citric acid? I'd like to try and see if I can keep my KLP tasting "bright" throughout its lifespan.
  3. atroph

    The Flavor Apprentice Flavoring Thread

    I wonder if it is olfactory fatigue where you are losing your sensitivity to that flavor. Fwiw my keylime pie does the same. 10% key lime 5% cheesecake 5% cheesecake Graham crust (Receipie from the net somewhere) The key lime seems to lose its pizazz close to the end of my 15 mL batch...
  4. atroph

    The Flavor Apprentice Flavoring Thread

    Be careful as it is a plastic tank cracker. It also destroys syringes almost immediately. It is a good flavor but at really low percentages. Sent from my 0PJA2 using Tapatalk
  5. atroph

    Rayon Wick - Better Flow, Flavor, Longevity, and Nic Hit!! - Pt.2

    Yeah IMO that is pretty tiny. I do 3mm coils too, and have a little leeway if I happen to run it dry. Usually I get a warning puff before it goes full gross. (TC wire/mod eliminated all of this and the worry of running it dry) 3mm should fit fine on your mutation. It may raise your resistance...
  6. atroph

    Joyetech Evic VT 60 Watt

    Correct. IIRC it was FW version 1.10 that "fixed" the 30W burst.
  7. atroph

    Rayon Wick - Better Flow, Flavor, Longevity, and Nic Hit!! - Pt.2

    Just reinforces what my earlier post stated. Lots of FUD out there and that person deems it significant enough to repost it for other uninformed to digest as gospel truth. And from there is spreads to everyone that crosses by that thread. Funny story, my wife had a minor surgery operation the...
  8. atroph

    Rayon Wick - Better Flow, Flavor, Longevity, and Nic Hit!! - Pt.2

    I believe it is the general vaping public consensus that OC is the best thing out there and the manufacturers have aligned to the mass market. Most are happy with it and don't really feel the need to switch. We rayon users are a minority of the vaping community. Lots of FUD out there against...
  9. atroph

    The Flavor Apprentice Flavoring Thread

    I have had luck with FW Blueberry. Just a simple custard mix with 10% VC 8% Blueberry and 1% EM to round it all out. I haven't tried other blueberries so I have nothing to really compare to, but I did like FW's version.
  10. atroph

    Rewicking Kanger OCC horizontal heads

    +1 on the ST v1 holes being good enough. I tried the OCC coils and to me it seems like the airflow was a little restricted as compared to the rebuildable deck. As for wicking I use Rayon and stuff the coil fairly tight and thin the tails out so they rest on the deck bottom. Cotton would be...
  11. atroph

    Rayon Wick - Better Flow, Flavor, Longevity, and Nic Hit!! - Pt.2

    What does it ohm out to? Looks like thick wire and some are touching, and you are doing duals. Might be too low for the Sig if it is TC wires. Quick tip on getting spaced coils nice and even is to wrap them tight to your desired # of wraps. Push them together on your tool du jour. Then grasp...
  12. atroph

    Rayon Wick - Better Flow, Flavor, Longevity, and Nic Hit!! - Pt.2

    No not really unless I have too much airflow and the flavor is less than ideal.
  13. atroph

    Vapers Tek throat hit on sale

    Ya know I've been vaping on this for about an hour or so, and the TH has calmed down a bit. Kinda like dripping first thing in the morning usually makes me cough, but after a pull or two and I am good to go. Just whipped out the mixers and ready to make a small mix. Anxious to try it out.
  14. atroph

    Vapers Tek throat hit on sale

    Just picked up a liter of the TH nic and whipped up a batch of 6mg unflavored MAX VG with about 20% DW since I don't get along with PG very much and need my juice to be relatively thin due to mostly tank usage. The TH is very much there as compared to their premium line IMO. It is very...
  15. atroph

    WISMEC Reuleaux RX200 TC

    Mine is just a touch crooked, but not worth damaging the LCD trying to tweak it. I do stealth mode so I don't usually look at the screen very much to really notice. You can easily remove the cover and attempt to move it yourself. Be very careful as the LCD and its connecting wire are very fragile.
  16. atroph

    WISMEC Reuleaux RX200 TC

    I was talking to a friend about the crown today and he told me that initial prime made all the difference in the world. He said to literally prime the coil head in your hand till juice is oozing out of it. He was getting dry hits and once he did that he was good to go. Normally if a vape seems...
  17. atroph

    Rayon Wick - Better Flow, Flavor, Longevity, and Nic Hit!! - Pt.2

    I am at 510 right now on Ni200. It really depends on your wicking and cold static resistance. In my experience my mod likes to drop to a lower resistance when it has settled for a while. What I usually do is lock it in when it has a little warmth to it. I am also building around 0.10-0.15...
  18. atroph

    WISMEC Reuleaux RX200 TC

    Water test? I am assuming when it first boils?
  19. atroph

    Rayon Wick - Better Flow, Flavor, Longevity, and Nic Hit!! - Pt.2

    I still maintain the reduction of tails principle, but for the MT RTA I'd still ensure that there is some wicking in the juice channels to help curb the leaking somewhat. I don't have one personally but by looking at the channels they seem to be rather huge and could stand to be stuffed a little...
  20. atroph

    WISMEC Reuleaux RX200 TC

    No problems here on 3.0.
Top Bottom
Forums
Products
Vaping.com
Star Suppliers
Blogs
Menu