I used mostly the Samsung 30Q which is also 3000mah. Read mooch's reports in the Battery and Chargers subforum.
RTDvapor has them for a fair price and is well respected around here.
The Endura T18 is a high quality piece in a compact size. Tank holds a little more than the i16 I think. 1000mah is more than the VV3 at 750 IIRC. Coil heads are cheap. Top fill and no spill coil replace out the bottom.
Famous guy on facebook
"Since I can't use cotton I have been using Fiber Freaks exclusively for the past year when rebuilding. Great flavor and easy to use."
What is Fibre Freaks?
Thanks for the insight. Glad I don't burn my rayon. Even though you have not provided proof that finished rayon actually contains any carbon disulfide or anything else.
Best it to learn how to time your draw and button finger so that you keep drawing after letting go of the button. The extra air cools the coil and that helps keep the gunk from cooking onto the coil.
I vape unflavored VG at 6mg with rayon wicks. I tried cutting down to 3mg and it didn't do it for me. Going back to 6mg I did notice the difference in taste that can only be from the nic.
And yes rayon really provides the true taste of what you are vaping. Good or bad.
I DIY unflavored 90VG/10Distilledwater. Was using 30ga kanthal and now 30ga SS 316L. 2.5mm coil 1.2 ohm wicked with rayon. I pull the ends of the unfinished wick up like bunny ears and slid the rba sleeve down to the base. Then trim just above the sleeve and shove the remainder down into the...
I have three STMs and never close them. Use them wide open. Leave them upright on the Kbox mini all night.
You might look at the Protank 4. Under $16 at Vapor Beast. I use the STM RBA in mine.
I took out the bottom pin/screw and all there is to seal it is a hard plastic cone shape. Apparently it is supposed to seat against the body when you tighten the screw. Any ideas on stopping the leak from this area?
Sometimes the screws that hold the end of the coil wire get goofy and act like they are tight but are not. Then the heat/cool cycle makes them loose and you get the high readings. Make sure that the wire is down in the slot and the screw is clamping down on the wire.
The other thing that...
I don't have a recommendation on where to buy but I mix 60mg nic in VG with VG and distilled water. I have a 250ml jar from sterile water that I marked at 160ml. I fill to there with VG then measure 20ml nic and 20ml of DW and pour it in. 200ml of 6mg in VG with 10% DW at less than $6 and I...
You might try changing your setup. Rayon flows more liquid, that cools the coil. You end up with more liquid in your mouth throat for the same cotton build. Try a smaller diameter coil = less wick or more watts/volts to vaporize the liquid better. Maybe more air flow as well. Trial and error
Cotton and rayon are both cellulose. Irritation is likely from increased liquid and nic delivered by rayon. Most people have cut their nic percentage by half at first.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.