Search results

  1. r055co

    Build Suggestions for 21700 Samsung 30T

    SS is lower resistance than NiChrome thus faster ramp up. Sent from my HTC 10 using Tapatalk
  2. r055co

    Ultrasonic coil cleaning

    For that the best way to go is just dissect the factory coil, I rebuilt for a bit my factory OG Crown Coils.
  3. r055co

    Ultrasonic coil cleaning

    That's why one just gets an RTA and/or RDA. And as I mentioned I tried cleaning Factory Coils before, that is a major reason why I got into RDA's and RTA's. I stand by my comment, cleaning factory coils is an exercise in futility. Cotton breaks down
  4. r055co

    Ultrasonic coil cleaning

    Cleaning factory Coils is an exercise in futility, seriously. Back when I used to vape factory Coils it tried cleaning with Vodka, Everclear even in an Ultrasonic. Bottom line is Cotton breaks down an you toss the coil. With my rebuildibles on average I swap my cotton weekly that is why on...
  5. r055co

    Build Suggestions for 21700 Samsung 30T

    Agree with too much wire mass, I use 317L SS fused claptons around 28x2/38.
  6. r055co

    What if

    It's very simple, I stocked up on gear that will last me well beyond my lifetime so what would I do? Ignore the law, continue to Vape and use both what I have stockpiled and participate on the Black Market.
  7. r055co

    New to RDA

    It all comes down to wire mass whether you use single, dual, or more coils. What's the gauge of your premades? Personally I use SS, more responsive and I'll run on my single battery Mech's I'll run dual 30x2/40 @ around 0.2Ω -0.22Ω. Very responsive, nice vape and it won't drain my batteries...
  8. r055co

    Reload Rta

    All my Reloads no issues with leaking, I don't even close the AFC while refilling and no issues with leaking. I'd say you wicking is the issue with the leaks. Also is it Authentic or is it a Clone?
  9. r055co

    Are you done stocking up?

    I'm well stocked, the only thing I'm doing now is insuring I have a backup of my top favorite gear. Even the new gear coming out now I'm not that excited about. Most all gear I see now IMO is just rehashing of previous design's so I'm extremely selective in what I get. I've actually been...
  10. r055co

    Hammer of God v4

    Got a response from Vaperz Cloud support, by design the switch is press fitted therefore totally unservicable. With the problems of chewing up battery wraps and a obscenely tension spring in an unservicable switch = failure. Sent from my HTC 10 using Tapatalk
  11. r055co

    Coil Question

    Replacing that battery should be #1 priority, quality batteries are cheap.
  12. r055co

    General Mod+rda question

    Yeah like the wick wars, Rayon vs Cotton, Koh gen Do vs Cotton Bacon, MTL vs DTL, etc. Unless someone is doing something incredibly stupid like 0.06 on a series or single battery mech it's all opinion. ;)
  13. r055co

    General Mod+rda question

    Exploding is due to thermal runaway or inadequate venting @Mooch
  14. r055co

    General Mod+rda question

    I'm certainly not the one getting so called ".... hurt". Just stating my opinion and disagreeing with your opinion.
  15. r055co

    General Mod+rda question

    For new Mech Users 1. Ohm's law, Steam Engine | free vaping calculators makes it easy and there's even an app on it for Android 2. Batteries!, take good care of your batteries and know them!!!!!!!! a. Avoid crap batteries like eFest, IMREN, MJXO, etc. who rewrap other batteries then grossly...
  16. r055co

    General Mod+rda question

    Oh so it's about # of Batteries then? Well that's a whole different subject not just Series Mods that you should have designated. Well we're going to have to disagree again, many of use Mech users also recommend parallel's over single battery Mech's due to more wiggle room with builds, easier...
  17. r055co

    General Mod+rda question

    Well if they build too low the batteries will vent at the same energy no matter, same rules same effect if you violate them. If a battery vents it'll vent the same for the same energy is stored, no matter if it's 8.4V or 4.2V.
  18. r055co

    General Mod+rda question

    Same rules apply, myself and many others our first Mech was a series mod. Series are no more dangerous, it's the same rules that apply.