Search results

  1. RedAlert

    OMG, what I did this morning and help needed...

    If it was "clean" toilet water, I'd say run some 91% isoprpyl alcohol over it to help ge trid of the water then put it in a bag of rice over night to dry out. But if the toilet wasn't flushed since the night before, I'd throw it away. Think of it this way, would you make a snowcone from yellow...
  2. RedAlert

    IMR vs Lion test and results

    I finally got my load tester completed and figured I'd try it out and post the results here. The two batteries I am testing are the AW 2200mah Lion 18650 and the AW IMR 1600mah 18650. I did three tests with each battery. All tests were done using a LR 306 1.5 ohm atty(that ohmed out at 1.51)...
  3. RedAlert

    Voltage test results.....

    I finally got my load tester completed and figured I'd try it out and post the results in the Reo forum, since all the tests were done using my Grands. The two batteries I am testing are the AW 2200mah Lion 18650 and the AW IMR 1600mah 18650. I did three tests with each battery. All tests were...
  4. RedAlert

    Atty issues?

    Put a new Cisco 306 on it this morning, and voila, nice and warm and smoke screens of vapor. I double checked the offending atty and all looks fine. I guess I'll never figure that one out. But all is we'll now.
  5. RedAlert

    Atty issues?

    That's 3.82v under load. The battery is reading 4.19 unloaded.
  6. RedAlert

    Atty issues?

    For a few days now, my Cisco 306 hasn't been getting very warm, nor is producing a lot vapor. I metered it with my DMM, and it's still reading 1.5 ohms. I'm running it on my Reo Grand with a AW 18650, under load its reading 3.82v so it's not a power issue. Is the atty just giving up? The...
  7. RedAlert

    Weird atty issue

    For a few days now, my Cisco 306 hasn't been getting very warm, nor is producing a lot vapor. I metered it with my DMM, and it's still reading 1.5 ohms. I'm running it on my Reo Grand with a AW 18650, under load its reading 3.82v so it's not a power issue. Is the atty just giving up? The...
  8. RedAlert

    Pulled The Trigger

    I just pulled the trigger myself, but for a P18.
  9. RedAlert

    Huge batteries: 2,000mAh+ as they pertain to expanding tube mods and reo grand.

    I'll try and answer the best I can here: 1) The ultrafire 18650 should fit any of these mods, but Ultrafire quality control is rather poor, so you may end up getting a battery that has too much plastic wrap on it causing it to not fit into the battery tube on the GG or empire, should be ok on...
  10. RedAlert

    Need advice please

    Any revision royal smokers cartos, clearomizers, fluxomizers etc have no filling. They are basically hollow tubes with wick strands that hang into the liquid, and feed the coil at the top. There is also the new G4 cartos that are bottom coils and no filling.
  11. RedAlert

    attys for 6v vaping?

    When I was using 6v, I always went with 3.5 ohm attys. Still plenty warm, without the horrid burnt tastes or popped coils. There are plenty of vendors that sell them. I personally like Ikenvapes the best.
  12. RedAlert

    Today is gonna suck!

    You can try and find a 7-11 near you. Most of them sell disposables for around $9. I've never used one, so I dont know if theyre any good, but better than nothing
  13. RedAlert

    Hr vs Lr atomizers. Difference?

    HR stands for High Resistance. You would use these for mods that are 6volts+(at 6.0v a 3.5ohm atty is rather nice) LR stands for Low Resistance. You would use these on a 3.7 volt mod to up the heat output by quite a bit. I know you're using a 1200mah battery, but is it an ego, or a "true" mod...
  14. RedAlert

    Atmos Copper... looking for feedback

    Seems like a good mod if you're into the "industrial" look. The only thing that really bugs me is having to push in the atty for a switch. Then again, I've never heard of one failing either
  15. RedAlert

    Sticky button on Reo Mini

    I get the sticky butto non my Grand about every 2 months. It only happens on the one I take to work. When it starts to stick, I disassemble the switch, pop the button out, and give everything a good cleaning. It's not the easiest thing to do, and you can mess up the mod if you're not careful...
  16. RedAlert

    iKenVape RY4 Steeping

    No steeping required for Ikenvapes RY4
  17. RedAlert

    Why Am I

    Nothing wrong with the Provari at all. Some, like myself, wanted to try it out. I found it to be exceptional in performance, but I just didnt need all the bells an whistles that it has.
  18. RedAlert

    510 Standard vs LR atties

    Hotter quicker, and also obtains a higher temp. Some people do use them on ego type batteries, but be warned anything less than 2.0 ohm may burn the mosfet out in the switch, rendering it useless
  19. RedAlert

    Best Atty bulk price?

    2 places come to mind. Joye eGo | Joye 510 | Electronic Cigarette supplies Tulsa | Batteries, atomizers, cartomizers, e-Liquid and more! : You can get 10 for 46.95 or PureSmoker.com - USA Electronic Cigarettes & USA Made eLiquid!!! : any combo of attys you like for a quantity of 25+ makes them...