Search results
-
Intro To The "3DFS ALPHA" By: Digitalciggz.com
yikes!!! Check the spring- I doubt it's the reason but make sure it isn't collapsed-- jimho
- Post #5,221
- Forum: E Cigarette Suppliers Forum
-
Intro To The "3DFS ALPHA" By: Digitalciggz.com
fair enough- I'll explain- I should have been more clear Range 4V-5V Setting | Duration | Average LED 1 | 00:21.8 | 4.1002 V DC LED 2 | 00:24.9 | 4.2993 V DC LED 3 | 00:25.9 | 4.4290 V DC LED 4 | 00:24.0 | 4.4978 V DC LED 5 | 00:28.2 | 4.5704 V DC LED 6 | 00:20.5 | 4.6470...- jimho
- Post #5,219
- Forum: E Cigarette Suppliers Forum
-
Intro To The "3DFS ALPHA" By: Digitalciggz.com
I think that's reasonable- if you put it in your pocket you should shut it off and take out the juice anyway. Plus the fact that it's capacitive...- jimho
- Post #5,211
- Forum: E Cigarette Suppliers Forum
-
Intro To The "3DFS ALPHA" By: Digitalciggz.com
You're misreading the data- Each line is the average voltage recorded over "duration" of me pressing the power button - each line is a different voltage setting on the EQ- the first line corresponds to the lowest setting (4V range, LED 1). the second line corresponds to the second lowest...- jimho
- Post #5,210
- Forum: E Cigarette Suppliers Forum
-
Intro To The "3DFS ALPHA" By: Digitalciggz.com
Well- either it was one of the short circuit tests I ran or inserting the battery upside down- its all too easy to do with these MNKE's because the tops are flat. I'd think that the device would protect from either - so this one- while minor has me a bit PO'd. I suggest putting a piece of...- jimho
- Post #5,190
- Forum: E Cigarette Suppliers Forum
-
Intro To The "3DFS ALPHA" By: Digitalciggz.com
Well- I just had my spring collapse- fortunately I have some about the same size and the unit is functioning fine. Anyone want to guess what caused it? It wasn't something I was deliberately testing.... It's real easy to do and I'm surprised the device doesn't protect against it (unless...- jimho
- Post #5,181
- Forum: E Cigarette Suppliers Forum
-
Intro To The "3DFS ALPHA" By: Digitalciggz.com
I'm not... but I offered.- jimho
- Post #5,179
- Forum: E Cigarette Suppliers Forum
-
Intro To The "3DFS ALPHA" By: Digitalciggz.com
Careful with those twisted tips from Nhaler- I love them but they aren't always consistent... and they do melt... from what I can telk they fit (I've tried 3 of them) but the lower lip may sit against the vent holes in the eq adapter partially restricting the air flow- The annodized aluminum...- jimho
- Post #5,178
- Forum: E Cigarette Suppliers Forum
-
Intro To The "3DFS ALPHA" By: Digitalciggz.com
What may be more of an issue is if you like using LR atties and want to be in the lower 4V range- So against a 2 ohm load here's more data for you to chew on... Duration is how long the power was applied and Average is the average voltage over that duration= Duration | Average...- jimho
- Post #5,173
- Forum: E Cigarette Suppliers Forum
-
Intro To The "3DFS ALPHA" By: Digitalciggz.com
Mine are correct- I measured them at the atty connector with a Fluke 289 meter...and tested the provari as a reference. Is not because the battery was fresh - in fact I needed to replace my battery by the time i was done testing. Again, being off by a few hundreths of a volt - even a...- jimho
- Post #5,170
- Forum: E Cigarette Suppliers Forum
-
Intro To The "3DFS ALPHA" By: Digitalciggz.com
LED brightness- Has anyone taken their EQ out of the house or near a window? Any thoughts on being able to see the green LEDs or is it just me/mine?- jimho
- Post #5,167
- Forum: E Cigarette Suppliers Forum
-
Intro To The "3DFS ALPHA" By: Digitalciggz.com
I wouldn't be too bothered by the voltage being slightly off- it's all relative- most of the increments are close enough to .1V for you to dial in what you want- it's just important to know if you are comparing two different devices. Where I think this device shines is with higher power...- jimho
- Post #5,166
- Forum: E Cigarette Suppliers Forum
-
Intro To The "3DFS ALPHA" By: Digitalciggz.com
Short Circuit Warning- Wanna know what your EQ will do when it detects a short? When you press the fire button, 1) it won't fire 2) all LEDs and EQ button will flash-- jimho
- Post #5,163
- Forum: E Cigarette Suppliers Forum
-
Intro To The "3DFS ALPHA" By: Digitalciggz.com
Voltage measurements- I've been reluctant to say the EQ hits harder than anything because it's VV and you have to compare apples to apples if you want to go down that road- So I pulled out my meter and ran some measurments- Note: my meter is accurate out to 5 digits- YMMV- this ought to give...- jimho
- Post #5,162
- Forum: E Cigarette Suppliers Forum
-
Intro To The "3DFS ALPHA" By: Digitalciggz.com
I measure by how much juice I vape per battery- I've been using it in rotation with MNKEs- not noticing any significant difference in amount of juice I go through between the MNKE and the AW IMRs.- jimho
- Post #5,106
- Forum: E Cigarette Suppliers Forum
-
Coil friendly flavorings?
I think you need the tank to go with it... not available till november. GG iAtty Rebuildable Tank- jimho
- Post #11
- Forum: DIY E-Liquid
-
-
dropping my provari
I've dropped my provari MANY times, and broken many attys.... The only time I had to have it repaired was when I threw it (slammed might be a better term)... so It can be broken- but not easily through normal dropping/tipping. -
Coil friendly flavorings?
I hear you on that- perhaps its something that reacts with the T&S in some juices - just saying it isn't happening with watermellon ... I'm looking at replaceable coils - it's infuriating to spend $3-$10 on a new atty because a nickle's worth of wick and wire gunks up or burns out. I've spent...- jimho
- Post #7
- Forum: DIY E-Liquid
-
New Batteries coming soon - ProVari Power 2500
David took care of me- as always .... just a rare mix up.... ProVape battery on the way. I'll do some side by side volume testing later in the week against a new IMR to give you an idea of how much longer % wise. Already sounds like a winner....