Search results
-
HIGO RDTA by Focusecig
Do you have a higher res version of that last pic?- ismokeinbinary
- Post #78
- Forum: RTA
-
Aromamizer RDTA by Steam Crave
Wicks look too long imo, I cut mine almost even with the build deck lip.- ismokeinbinary
- Post #2,900
- Forum: RTA
-
Aromamizer RDTA by Steam Crave
I would think that will cause wicking problems. Let us know how it goes.- ismokeinbinary
- Post #2,897
- Forum: RTA
-
Aromamizer RDTA by Steam Crave
I cut mine even with the top of the posts, but my coils are 7 spaced wraps so it's barely any cotton at the top. But mine do get a little brown after a few tanks when in VW mode but in TC they stay white for a long time..- ismokeinbinary
- Post #2,895
- Forum: RTA
-
-
WISMEC Reuleaux RX200 TC
My RX200's front panel paint has a chip in it. :( I treat this thing like a baby, I did notice when I received it there were two spots where the paint job wasn't perfect, seems those areas are prone to chipping as one has already done so. Oh well, it was only $37, I'll probably order another...- ismokeinbinary
- Post #1,636
- Forum: Devices
-
Geekvape Griffin RTA!
- ismokeinbinary
- Post #193
- Forum: RTA
-
Aromamizer RDTA by Steam Crave
I'm sure V2 will have direct airflow, an AFC ring, and possibly top fill. Hopefully if they do a top fill it is more like the Crius and less like the Bellus. I'm really hating my Bellus' top fill, I guess I didn't wick it 100% correctly and it emptied a whole tank of juice onto my VTC mini in...- ismokeinbinary
- Post #2,869
- Forum: RTA
-
Vape wild?
I made the mistake of ordering 120ml of Wrecking Ball, to my surprise it wasn't very good. But if you want a banana version of (S+C)2 try Circus Bear, it's still my favorite VW juice. Circus Bear is the only juice I've ordered 120mls of on every order so far.- ismokeinbinary
- Post #520
- Forum: E-Liquid
-
WISMEC Reuleaux RX200 TC
I've used a micro screwdriver to press on it but it wont budge, any suggestions?- ismokeinbinary
- Post #1,568
- Forum: Devices
-
WISMEC Reuleaux RX200 TC
The RX200's 510 pin is supposed to be spring loaded, right? Because mine is stationary and in the fully compressed position, if that's the case..- ismokeinbinary
- Post #1,566
- Forum: Devices
-
Helping a spouse make the switch...
I'm in the same boat OP. My SO absolutely HATES vaping. It drives her crazy that I like to rebuild my tanks and that I post on ECF. I'm not quite sure why, but after giving her a VTC mini and a Bellus tank I've backed off, I don't try to get her off cigarettes anymore. Every time I order juice I...- ismokeinbinary
- Post #18
- Forum: General Vaping Discussion
-
Those People
I've noticed a large amount of vape-hate on fb. Honestly the memes are getting on my nerves. We should all make memes bashing analogs and plaster them all over fb. Just my opinion.- ismokeinbinary
- Post #26
- Forum: General Vaping Discussion
-
Aromamizer RDTA by Steam Crave
Unkamen? Heard they got every wire..- ismokeinbinary
- Post #2,820
- Forum: RTA
-
Aromamizer RDTA by Steam Crave
This right here. @Chris863 @cjpeltz- ismokeinbinary
- Post #2,772
- Forum: RTA
-
-
WISMEC Reuleaux RX200 TC
I'm very impatiently waiting for another update. My VTC mini's temp control is a lot better than the RX200. When will we get custom TCR?? :(- ismokeinbinary
- Post #1,480
- Forum: Devices
-
Aromamizer RDTA by Steam Crave
I actually did my first spaced coil build in my Aromamizer today. SS316l 7 spaced wraps, 3mm ID verticals. Came out to 0.21ohms. Lots of popping but I figure that'll stop once it's broken in. So far it's performing better in TC. I have the same amount of airflow as always. I think the...- ismokeinbinary
- Post #2,759
- Forum: RTA
-
Aromamizer RDTA by Steam Crave
Ohhh, I was under the impression you also removed the lip on the top of the tank. Lol- ismokeinbinary
- Post #2,740
- Forum: RTA
-