Search results

  1. Dieseler

    eGo ONE tank series – CLR coil

    Only wire used is kanthal for clr's and also for zenith coil heads yes i have rebuilt a few and made them horizontal coils not as easy as clr's though but can be done with a little work. As for insulators have yet to ruin or burn one up vaping around 10 -12 watts. No TC here never tried as quite...
  2. Dieseler

    Finally, I figured out the Brunhilde MTL RTA

    Filling was a problem the 1st time trying as i always used hypo needles that hold total of 10ml over But the needle was way to long for Brunhilde tank so i just cut the needle to fit problem solved. As for juice coming out the airflow or building up under cap that has never been a problem here...
  3. Dieseler

    Whats new in MTL?

    Have some original I Stick pico's still new in box bought some years back here is one recently opened showing you a 23 mm diameter Brunhilde MTL 5 ml capacity tank with Top Airflow and fill. Its airflow has 6 different size pins to customize the airflow with the 1.4mm being favored in this...
  4. Dieseler

    Innokin Zenith MTL tank--Phil Busardo

    Yes exactly pull out old cotton few quick dry burn pulses to clean coil then wait a minute or two so coil is cooled down and insert new cotton.
  5. Dieseler

    Innokin Zenith MTL tank--Phil Busardo

    Two stainless screws from a different tank screwed into two opposite holes and then ground down as flush as possible not pretty but works. Installing a horizontal coil was not to bad , have to change cotton more as it just goes thru the coil only not placed in there like the original vertical...
  6. Dieseler

    Innokin Zenith MTL tank--Phil Busardo

    Made a horizontal coil out of an original 1.6 ohm zenith coilhead . Not sure what a zcoil is have not kept up with the different models that came after the original Zenith tank.
  7. Dieseler

    Innokin Zenith MTL tank--Phil Busardo

    Thats the part i could not get out some months back out of a 1.6 ohm Zenith coilhead but did get all old cotton out and made a horizontal coil like a clr coilhead . After a few fails with floods etc plugging 2 of the 4 holes ceased all problems .
  8. Dieseler

    Video Review: Techmod and the Unlimit

    Hats off to you Anna for the video as i recall doing one in yard about fig plants i grow and i totally stunk at it then came some nice comments and could not reply because i forgot the password and still cannot get figure it out after all the years gone by i gave up trying to.
  9. Dieseler

    Best MTL RTA to date

    As mentioned the Brunhilde is a good one in my opinion.The 5ml ones being used for several months now. It gives 6 possible levels of airflow with 1.4 being used on the 3 in rotation here. Never leaks - diy e-liquid used is 93% PG. May i suggest whatever you consider look up a video to see whats...
  10. Dieseler

    Rebuildable drop in coils

    Superuser the joyetech clr as mentioned in this thread is a very good and simple setup and they are made to be rebuilt been using them for years in rotation . The cotton just get changed out when spent and eventually the coil itself will get re made. As a matter of fact its the joyetech clr...
  11. Dieseler

    eGo ONE tank series – CLR coil

    OR where have you dropped your tank such as the time it was on the bathroom sink when shaving and knocked it right into the toilet.
  12. Dieseler

    eGo ONE tank series – CLR coil

    Late to the gathering I have had success re -seating that part by putting a small socket a 5/16 or 9/32 will clear the 510 threads and then tapping it with a hammer. : )
  13. Dieseler

    Why Are All Mods Made Like Crap?

    Starting to think the DNA 18650 battery mods i use will outlast me .
  14. Dieseler

    Legal Enjoyment Today

    Tried the face mints last night took 3 puffs of a joint and was glad this purchased was made and now have a mental note to buy again in future when available. Comparing it to ice cream cake and same intake the face mints is stronger it hit me fast and hard then it wanes with time the ice cream...
  15. Dieseler

    Legal Enjoyment Today

    Shown is an 1/8 by Cresco called <Face Mints> its a indica dominant strain that will try this evening.
  16. Dieseler

    Anyone have a favorite device of all time?

    From 2011-2013 Vamo, and smoke tech mods with mmvapors did genny on top still have them but sitting and waiting to be used again.How about a vamo cut in half shown below as well with DID on top i recall buying the kit minus the vamo cut my own. Still have all of these plus others. Not shown My...
  17. Dieseler

    Help me wick my brunhilde MTL

    It may be your e-liquid as you said does not make sense after 8ml of juice one has to change cotton. I have 3 in rotation now and do not keep track of how often i change the cotton but its certainly more than 2 tank fulls. I do use a 3mm diameter kanthal coil about 1.03 ohm @12,5 -13w and when...
  18. Dieseler

    Anyone Know A Good Durable Mod That Lasts?

    Haven't any problems with evolv's single 18650 dna mods including the firing button. Have built a few vv years back before dna vw came out still have them but not in use. From 2012 bought board on ebay and also the meter if i was to build another now a days would use a Dna 75c for personal...
  19. Dieseler

    Smok Stick 80w overheating

    If you try another atty with same results then the firing button is stuck downward either the outside button on mod or the button coming off the board that the outer button pushes down on. On many there is a small spring that forces the outer button back out to release itself from the board...
  20. Dieseler

    Legal Enjoyment Today

    Northern lights is one i would like to try if and when it becomes available at 1 of the dispensary's in area . Have read good things about it .
Top Bottom
Forums
Products
Vaping.com
Star Suppliers
Blogs
Menu