Search results

  1. Hitmetwice

    Comment by 'Hitmetwice' in 'Guide to Choosing a Battery Charger'

    You Da Man Bad, one of many amazing contributions, you have helped many, many, of us "get it", even me (to a degree)haha. Much Respect, Many Thanks Bad, Ron.
  2. Hitmetwice

    Rewick the iclear30 head

    3mm cotton yarn, 4 strand, 1 strand=0.75mm 1mm cotton string, 4 strand, 1 strand=0.25mm (of course doubling over the 1mm string would work too. I'd advise to untwist the braid first though) Using 1 strand of each equals 2mm. when doubled over the folded piece on kanthal(used for threading the...
  3. Hitmetwice

    Re wick the Protank/Evod Head.

    The inside diameter of the 2.5ohm coil is 1.4-1.5mm. Using one strand of 4 strand 3mil. yarn doubled over a folded piece of kanthal for threading through the coil is working better than the original equipment.imo. No flooding, no burning at 4 volts power hitting it. Wicking is better than ever...
  4. Hitmetwice

    Comment by 'Hitmetwice' in 'Re-wicking a stardust 2.0(V3) head with cotton.'

    You're very welcome hheathernhudson, hope your vaping experience improves.
  5. Hitmetwice

    Comment by 'Hitmetwice' in 'The Stardust center post is no longer centered "OR" the tube is leaking fix.'

    Hello GaryParr, I've found "the puddle" under my stardusts once or twice in the past myself. The V3 versions are the easiest ones to work with, these are the ones I'm referring to, and using. The cause('s) for me was either the tube had pulled up a bit on one side as described by the fix...
  6. Hitmetwice

    The Stardust center post is no longer centered "OR" the tube is leaking fix.

    This is for V3 units but may loosely apply for earlier versions also... Found that after the unit got torqued a bit, in my pocket, I noticed that the center post was no longer lining up nicely with the drip tip. I discovered that replacing the tube was the remedy for this but on further...
  7. Hitmetwice

    Re-wicking a stardust 2.0(V3) head with cotton.

    This works with the vivinova heads as well. What you'll need... An old replacement head. Plus.... 1mm. and/or 3mm. Cotton wicking material(1mm.string or 3mm. yarn) Three to four inches of kanthal or nichrome wire, or similar (for threading the cotton through the coil) Electronic screwdriver...
  8. Hitmetwice

    Stardust 2.0(V3) Tweaks.

    Stardust 2.0(V3) started seeping e-liquid onto the top of my battery through the center post the other day. I've been cleaning, dryburning, replaced the silica wick with cotton(a few times) and been using it for weeks now(same head). I figured it was at the end of it's life and was still...
  9. Hitmetwice

    Hitmetwice

    Blog by Hitmetwice
Top Bottom
Forums
Products
Vaping.com
Star Suppliers
Blogs
Menu