I prefer catching wire under screw head. Makes a very secure connection. There is no seat in through post hole terminal; if over tighten it will cut coil cable.
#5 was made from one piece of cable which I prefer.
I don't use button top 650s. My FT velas were kinda junky out of the box; surprise:) . I rounded and polished the end caps. Tuned the switch. Cut a few extra pins.
ATM my 2 FT velas are my favorite 18650 mods. Just something about a rounded switch button and one piece tube. Near impossible to...
#5 coil face is 2.5mm from inside wall of air cap; measured at center of coil face in the line that passes through both holes and center post. Centerline of coil face is 5.5 mm elevation above deck lip. Cap clocking affects air hole to coil distance from 1mm to 3 mm.
Your welcome. Nice of them to drill it out for ya. Drilling SS is a bit of a pain even w/ drill press.
Once hole is 5/64" it is easier to step larger because working w/ bigger stronger bits. I can live w/ 5/64" all day long.
All these coils are close. In a today's 100% PG competition the...
I have 6 IGO-W's. Drilled to different sizes. My favorite is 0.6 ohm dual coil with dual 5/64" air holes. Big enough for lung pull. Big enough for dense big clouds. Small enough for mildly warm vapor and good flavor.
3/32" isn't a big difference. 1/8" if main objective is clouds at expense of...
I think chamber size matters. Vapor from 14.5 mm topper is warmer than vapor from 22 mm topper with same coil positioned same distance from air feed. 14.5mm topper also has advantage of extremely short hot legs; less wasted hot leg energy.
I suspect aerodynamic flow is better in small chamber...
I saw that thread. Is that really going to happen? Is some lengthy process of appeals underway? Is that a wink wink not to be enforced set of laws? Why people aren't rioting in the streets?
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.