Yup this has to be a problem. Must've gotten a defect or something because I've tried over6 different could and that all leak.welp, time to pawn this off on someone else on eBay lol
It is not threaded. Simply fitted on their with a little grease it looks like.. But it comes off way too easily and I've tried everything to get my tank to stop leaking it must be from this.
The whole entire top piece(drip tip, white seal, and metal) has seperated from the chimney part that connects to the top of the coil heads. Is this supposed to happen? I'm worried this is causing my tankto leak.
The whole entire top piece(drip tip, white seal, and metal) has seperated from the chimney part that connects to the top of the coil heads. Is this supposed to happen? I'm worried this is causing my tank to leak.
Can anyone tell me where to get a replacement mutation x v4 drip tip, or tell me what size this drip tip is? The first day i get my new vaporshark DNA40 and the mutation x v4 by indulgence i dropped this baby on the ground HARD and i ended up losing my drip tip for the v4. To my luck, this drip...
The negative post on my yep RDA which I got from: rdavapor.com is milled terribly. I can barely get the screw to back out of the post hole and I also can't get the screw to hold thread enough to tighten the connection. Should I contact rdavapor and ask for a refund? A return? Will they even do...
Okay, I'm looking to shave off a good amount, not just dull the tip. If I shave off a decent part of the bottom of the screw, will it still thread into the post correctly?
Has anyone tried to sand down their screws that screw into their RDA posts?
If I sand mine down, do you think i will be able to still screw it in or will the threads be messed up
I got an authentic yep RDA off rbavaporstore.com. The screws that go into the posts are so long that, with 24 gauge in the post, the screw won't start to screw into place. I got 28ga to fit and I can screw them down but 24 gauge doesn't work. Is there anything I can do to change this?
I was...
With your evod twist, swab out the contact that you spilled juice on and then the contact may have gotten pushed down. If you have small tweasers or the scraping tool the dentists use you can wiggle the contact up a little bit to get it sitting properly to make contact with your tank.
Sent...
Ok so I ordered from VR a couple days ago. I ordered a brass stingray clone and an igo-w3. When it arrived I did not get The drip tip with the mech mod and I got a normal igo-w. Not an igo-w3. I obviously had to open it somewhat to see what I got but it will go back in its packaging. What should...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.