Search results

I just bought an iHybrid Pure. I do not know if I should just leave my ribbon vertically and wrap it below the positive and negative screw that way or if I should bend it flat horizontally under the screws so that it lays completely flat? Please help.Thanks in advance!

What size ribbon wire do I need if I'm using 30 gauge and 28 gauge?

I just setup up a new wick and coil around 6 o'clock. My ohms were 1.1 now at 11:43 my ohms read at 1.2 to 1.3 on my provari and I'm sure it will continue to rise. I know the ohm will rise over time with use but already? Is this normal? At this rate by tomorrow night it will be around 1.5...

Can my air hole be too big and causing flavors to seem muted on my AGA-t2? I drilled my air hole to 11/16 which equals to 1.5875 mm air hole. I have read people drill out to 1.2 mm. Is this the reason my flavors are not as flavorful?

I have an AGA-t2. Im using a 32 gauge kanthal wire. 3/4 wrap. And I keep getting 1.9 ohm. The other day I unwound the last wrap and had a 2/3 and still had a 1.9 ohm reading on my Provari. What do I need to do? What's wrong?

Which is better, a hollow wick or solid?

I just put some Mad Murdock's Agent Orange in my rank for the first time with a fresh wick and coil put it barely has any taste. I found this to be a surprise since Pluid has such a strong taste. Is this normal or am i doing something wrong?

Is Mad Murdock's Agent Orange safe in any tank or is like Pluid?

How can I minimize dry burn hits on my AGA-t2?

Why do I have so much condensation/juice on the top of my aga-t2?

I'm about to try Pluid for the first time. Should I rebuild the mesh wick and could on my AGA-t2? My wick and coil is about less than a week old and I have tried a few different juices in it. Please help with your opinions and experiences. Thanks.

Help! Where do you buy your SS Mesh and what deals are you getting? I am trying to buy some mesh but do not know where the best place to get it.

So I noticed that there are different ss meshes. Some are 400, some 500 and so on. What's the application for the different types of mesh?

Why am i getting a lack of taste in my AGA-t2? I thought I am suppose to get maximum flavor. My resistance seems kind of high as well. It's at 2.6. I used 32 gauge kenthal wire and wrapped it 4 times. Using 400x400 wick.

I just bought this atty a couple of hours ago. The top of the coil is not touching the wick and I wanted to replace it? Can I while there is juice in tank? How should I go about this? I took a little crash corse while I was at the vape meet and rebuilding so I know a little but not a lot.

I decided to start this new thread to see what strength Pluid do people vape verse the strength they normally vape. So here we go. Go ahead and post what strengths you vape.

What Pluid strength should I buy? I normally use 12 to 16. Should I cut it with Mad Murdock's Cutter or should I get 20mg and 10 mg Pluid and mix?

What's the best rebuildable atomizer for a beginner and where can I learn how to rebuild, put on wicks and coils and learn what I should use? Thanks in advance

How much cutter do I need to add to a 30 ml of Pluid to get it as close as possible to to 12 mg? What's the formula?

How can I get my hands on Mad Murdock's Radiator Pluid?! Any suggestions? Do I need to start looking around on a certain date? I don't know where to start! Please help