Search results

Yea I tried all of my tips in there. None of them would fit. I eventually found some 40 grit sandpaper, rolled it up around a screw until it was really snug in the connector, then I proceeded to press down and keep turning and grinding until I got it down to a suitable diameter. Only bad...

Unfortunately I don't have access to the proper drill bit or a press :oops: I have been using sandpaper, and little by little it seems to be opening up, just not as fast as I had hoped. Oh and the atty is all stainless steel.

Soooo not sure if this is the right place to put this buuuuuuuuuut, I just purchased another rba and it happened to come with a drip tip. I didn't look at it much and just purchased the atty. After I got home, I noticed the stock tip in it was amazingly tight in there and I actually thought it...

I appreciate you offering but I am looking for these, just want to get them locally so I don't have to deal with shipping and so I can support a local shop.

Just went to Vapor Vortex yesterday and all they had was silver wire, no pre made already soldered ready wires :frown: It doesnt look like kidney puncher had the pre made's either.

Hey there VIP'ers! Anyone know where I can get some resistance/non resistance wire here in phoenix? I've tried a few places, and can't seem to catch a break. The only place that even carried non resistance wire that I have talked to so far was Vapor Vortex. Any help would be great since I just...

Any idea where I could buy a pin to try out?

I would check the threads to see if maybe there isnt some kind of obstruction in the threads. Sometimes the makers leave a little scrap metal in there when carving out the threads.

Yea I figure that will eventually happen, I've been running a .7ohm coil on it for a week solid and no catastrophe yet. I suppose when it does go out I could replace it with a free floating pin, no?

It's spring loaded for sure, the smaller top part of the firing pin sinks into the larger base. As far as the smaller spring being used to help with conductivity, I have no clue lol.

So there is a local shop around where I live and they sell these Nemesis clones. However, after doing a little researching, they aren't like any of the other clones that I have found on the web so far. From what I gather, all of the clones I have seen, including the original, have a telescoping...

This is by far the coolest vape stand I have ever seen! Excellent!

Congrats Stump and yes! Calling all lurkers! Be known and lets be social!

hahaha! Might have to do that and take my act to the street to earn some extra money for vape gear!

On a sub note... How would you go about cleaning them? Do you think they could be boiled for a minute to be sterilized? Or would that be too much heat for the plastic?

I was thinking the exact same thing. Might have to go check out other parts of the forum to get a good idea on where to start with this.

Congratulations on fully making the switch! Its deffinetly useful to have some extra nic on hand to mix in when you need that extra little bit to get you through the rough patches.

Looking at my stash of vape gear I recently noticed I have a TON of empty bottles of juice laying around. I would like to re-purpose them instead of tossing. Does anybody have anything specific they like to do with their empty bottles?

I totally understand where you are coming from. Like others said, it would be wise to have a tank with a higher nic juice in it. I can tell you however, it has been 7 months for me and there are still times when I get a strong craving. During those times, I usually just try and pull myself away...

I deff don't throw them away, but I have a couple of 15ml bottles laying around here somewhere. I usually just leave them be until a rainy day hits and I don't have the means to get any more, or like others say, I just give it away to a friend.