Search results

The button got stuck on my 18350 mech mod built at 1.7 ohms and I didn't notice it was firing until 3 minutes later. The mod was really hot when I released the fire button. I'm guessing that before the 3 minute continuous discharge the battery was around 4.1 V and after when I put it on my...

The only ones I'm aware of are the Berserker Mini (31.7mm), Hastur Mini (30mm), Doggystyle (35mm), and Pico V2 (30.5mm). Any others out there? Which is your favorite?

From all the ones that I've seen, the Espion Solo seems to be the most compact. Is there anything out there that's more compact?

If you could only have one tank style vape system would it be a Squonker or an RTA? RTA: Pros Cotton is always fully saturated Feeds automatically Atomizer/tank is more compact Doesn't leak when turned on side Faster refill Cons Cotton is always fully saturated (less flavor) Adds height to...

I'm interested in setting up a bottom feed atomizer for vaping Nicotine Salts. Most of my friends use Juuls or refillable Nicotine Salts specific vapes and I have grown to really enjoy the hit. I assume it will have to be something single coil with restricted airflow that I can build high...

What's the recommended 21700 for single battery DNA 75c mods? Based on Mooch's chart it seems like the Vapcell Gold has the best tested mAH to tested CDR rating at 3900mAH / 30A.

I started squonking a year and a half ago. At the time I ordered the Pico Squeeze and Coppervape based on recommendations from this forum. The Pico Squeeze died about 6 months ago, it would continue firing even when my finger was off the trigger and I had to take out the battery to stop it. It...

I have the SXK Hadaly, and SXK Shift BF on order along with a Pico Squeeze. I just now ordered the Coppervape mod and I would like to order a BF rda that will sit more flush than these 22mm rda's (I know this is just an excuse to buy another rda, but clones are cheap) Preferred: -dual coil...

I have the SXK Hadaly, and SXK Shift BF on order along with a Pico Squeeze. I just now ordered the Coppervape mod and I would like to order a BF rda that will sit more flush than these 22mm rda's (I know this is just an excuse to buy another rda, but clones are cheap) Requirements: -dual coil...

Looking at the Pico Squeeze and the Coppervape with a Hadaly. Is there anything smaller than these setups? Is there any benefit of the regulation on the Pico Squeeze versus a mechanical like the Coppervape? Since you can't adjust the wattage I don't really understand the benefit of the...

Ive been smoking too many analogs since I lost my Reuleaux. I'm looking to get back into vaping with a more compact/portable setup, really looking for the opposite of my old Reuleaux. I want something with an internal lipo battery that has pass thru charging while vaping. Also, something that...

I just ordered a Reuleaux and I would like to get a fresh set of batteries to use specifically for this mod. The only batteries I have purchased in the past are vtc4s back when I used to use mech mods which was over a year ago. Since then I have been using tc with ti gr1 and ss mostly but I...

Coming from mech mods I almost exclusively use drippers so i want to know which of these devices would work best with a titanium build in an rda. I had the snowwolf on preorder but I didn't realize that it doesn't auto detect titanium wire which means that I would have to dial it down about 80...

Coming from exclusively using drippers I am now looking for a tank that covers all bases. Ideally I want a tank that has great sub ohm and temperature control disposable coils but one that I can also rebuild when I run out of disposable coils. The only tank that I have found that does all these...

Coming from mech mods I almost exclusively use drippers so i want to know which of these devices would work best with a titanium build in an rda. I had the snowwolf on preorder but I didn't realize that it doesn't auto detect titanium wire which means that I would have to dial it down about 80...

Hey ECF, anybody have ideas for a DIY veritas insulator? The ones on the ihybrid mods site are $3 plus $6 shipping and they're sold out :facepalm:.

Hey ECF, anybody have ideas for a DIY veritas insulator? The ones on the ihybrid mods site are $3 plus $6 shipping and they're sold out :facepalm:.

Hey ECF I want to buy a copper top cap for my veritas so it matches my stingray but I've heard that copper is not something you want in your rda. Can anyone confirm or dispute this?

Hey ECF I want to try out some vaping specific resistance wire. The three wires I know of are Royal Wires, GPlat, and Hotwires. Are there any other niche wires out there? And if you have experience with any of these, which is your preference and why?

Hey ECF I want to try out some vaping specific resistance wire. The three wires I know of are Royal Wires, GPlat, and Hotwires. Are there any other niche wires out there? And if you have experience with any of these, which is your preference and why?