Search results

It absolutely works I stopped a five pack a day habit with vape after smoking forty years or more

Im running 26ga at .7ohms on one At 20 watts great flavor

Yes once the press fit positive pin wiggles just slightly loose and leg length has you wondering if coil is bad the positive pin can still make contact even though it is loose To much tension on the coil will loosen the positive pin Ive had mine pop completely out just installing a coil

Leg length as well as the positive post is pres fit i have 3 tanks with my builds all the same except for juice flavor and they do close to the same effect

Other than the 510 pin it seems to work fine for ss as well as kanthal its an easy fix especially if it came from a Chinese company if sent back to them all they will do is put another press fit in

a quick fix for the preditor for when the 510 pops out Put a thin film of JB weld around the bottom where the bumps are clean it with alcohol first It will never come out I pulled mine out intentionally to keep it from popping out by accident when Im out and about The mod works fine other than...

I do the same with mine and get great flavor with a 2.5mm coil at .7 ohms

The IPV D3 is small I have one thats been used almost exclusively for the last 6 months and still working fine It will handle 25mm tanks Does not do ss coils The paint has started coming off mine but i carry it in a pocket with keys and other stuff Battery usage is good

I had the same problem while installing a coil I keep pressure on the positive post while positioning the coil to keep it from happening

I have three nanos so far never had flooding one stays on its side always for the flooding do you have the wick down in the juice holes I put my wicks just barely in the holes making sure there is no open space I dont get dry hits nor flooding

The original Merlin is an RTA this your looking at is a RTDA Different critter all together different feed system this one might not leak like the original Waiting for more info before I buy one

Thats why you never lay your setup on a picnic table ants and honeybees like e juice lol

Im getting the same over my 4 merlins with no leakage Mine is a 2.5mm 26ga single kanthal

Its strange some get great flavor and others get no flavor at all I get great flavor on multiple builds

For a 2.5mm kanthal coil at .6 ohms I start at 15 watts and go up until I get the best flavor and clouds usually 20 to 25 watts

Out of curiosity I did an experiment Usually I run a 2.5 mm ID kanthal coil at between .5 and .6 ohms even with the holes and centered to the holes at 25 to 30 watts then it just gets to hot for me great flavor and clouds air flow wide open no dry hits So I took a 2.5mm kanthal coil at 1.05...

ricks it just sits in the well as a pressure fit it sits around a pin in the well I must have twisted a little hard and it cranked out

No its a firm fit once I reseat the positive post I was positioning a new coil and twisted it and the positive post just popped out It just sits on a pin in the well No problem once I reseated it and no play in the post at all

Just as a warning in case no one else has done it yet lol The positive post can pop out when bending a stiff 26ga kanthal coil it happened to me It goes back in easy enough and seems ok afterwards i did it today and didnt reseat it and my ohms bounced around

Im using 2.5mm I.D single kanthal now it seems to be the middle ground of having enough wick to fill the juice holes and still having a smaller coil Im almost getting flavor overload Im vapeing a strawberry,coconut,pineapple juice and the flavor is strong and clouds a great