Search results

Jjvapes.com

On the device, just below the power button printed in the same paint and font style as the other buttons, looks factory, just hoping I didn't get a fake or something, if you tell me how to put a picture here I will

Quick question, just got mine in today, just below the fire button there's a number there 060. What's this? I haven't seen numbers there in any picture of the ipv2 serial number inside reads L0252

How many posts are left?

I think there's a slight deficit here...

Round four!

Round three, here we go!

For this round

Sounds like you might have put too much cotton in this time, best method I've found is not to run the wick through the channels, but pinch the ends up while sliding the chimney down, thread the chimney base on, then tick the ends down LIGHTLY, also, I trim the wick ends to where they are as long...

Efest has a purple 10amp 350 you'll find them at illumination supply for like 5 bucks, I run my igo single coil, drilled the air hole out just barely larger than stock,try to get your ohms at right around 1 if you have 28 kanthal, probably 4 wraps will do, should solve your problem, as with...

What I like: you carry hcigar products, imo best clones for the money, wish you had taifun accessories. Site is clean, and professional, easy to navigate on mobile. What I don't like, every time I shop online and find something that interests me, the very first thing I'll do then is look for...

We buy nic in small batches, use it up within 3 months, it stays sealed in Amber glass in the back of a dark closet

Thanks for having the contest!

Looks like we've got a democrap in our hands.

Mid cities vapor, n Richland hills

Mid cities vapor, north Richland hills, they're recipes stay consistent every time I go there, no bad batches, or off tastes, and a big selection of accessories

Best clones I've used were from hcigar

+ 1 on fasttech cheap and free shipping

Try to open your wraps slightly, around .9-1 ohm, cotton wick, don't choke the coil with the cotton, let it pass through the wick holes no more than 2mm, fluff the ends out a bit